开云体育

Im using the latest version and the CW decoder works for me.

Jens, I don't use CW so I can't help you there. With 0.19.0, I have no problem with my GPS USB Dongle. It works correctly, syncing my internal time to GPS. I did a write-up a while back that described

https://www.youtube.com/watch?v=s3UX4OlHGKo :)))))))))

Only in version 0.17 the CW-decoder was very good working , in all later version the cw decoder works not ... !! Same is with GPS-Dongle: It works only good til version 0.17 , in later versions also

This all feels like good advice. I *can* get the ALC to kick in if I use the ATU, but doing so seems to carry a high risk of causing the USB ports to reset, despite putting chokes on every cable I can

Interesting.? Some months ago I read a post from Oleg saying for digital modes the ALC should be set about 8 using his R1CBU firmware, so that's what I've been using for several months now with no

I was confused for a while about ALC as well, since the x6100 is my first HF radio, and the ALC seems to be backward (starting at 100%) on Xiegu radios. With stock software: * I set the power where I

A general rule of thumb that applies equally to any rig is to preset the power output to some level (for example 4 watts) and then increase the TX audio gain (either via the rig or computer) until the

Hi all, I got an X6100 over the holidays and I feel like I'm losing my mind a bit trying to sort all the issues I've been having. I've gotten the bulk of them squared away, but I'm still having some

Thanks to the wayback machine, I completely forgot to try that! I now have the 0.17.1 version, so i'll have a go with it later this week. Thank you to all that replied and helped me get the elusive

Wayback machine for the win: https://web.archive.org/web/20230625214356/https://r1cbu.ru/index.php/home/files/summary/3-x6100/15-x6100-r1cbu-0-17-1

It MIGHT take a bit for it all to get thru the internet de KB9AVO <guillermo@...> wrote:

It worked for me this morning from this link here: https://r1cbu.ru/index.php/home/files/summary/3-x6100/17-x6100-r1cbu-0-19-0 I hope this works for you. 73 de PY2BIL

It sounds like you may have ruled this out, but erratic behavior as you describe is almost always a feedline issue such as corrosion or loose junctions. -- 73 de K9NUD

Scott, that didn't work, nor will email I doubt as the file looks to be above 100mB, so way to large for most email attachments. You would have to upload it someplace, like Mega / Dropbox or

Thanks Michael, I'll give it a try. 73, Rick K8BMA wrote:

Erm, you are actually talking into the mic I presume, not just PTT? You need to talk for RF to go out!

Rick : I had a similar issue when first using my X6100 portable with my Alex Loop.? On a hunch I added a common mode choke to the feedline and then it behaved normally. So, this could be a sign of

I noticed recently that while sending CW, the X6100 SWR meter consistently reads about 1:1.1 to 1:1.2, but at the end of the sequence, it bounces to around 2.5. On slow CW, 10 wpm, it bounces on each

Get a shielded cable. ?Insert a USB ground loop isolator between the computer and transceiver. Move the transceiver further away from the computer. ?One or all of these suggestions should help with