开云体育

I'll take a look a bit later. If you familiar with ghidra - you can try to find corresponding place in code using attached files as a guildeline (for 1.1.8) -- Georgy // R2RFE

Would it be too much to ask if you could do this for base 1.1.6_160 also? Thanks.

Regarding the Max voltage mentioned by Xiegu, yes, it might work above 13.8 Vdc. but the radio will run hotter. I wouldn't trust the Xiegu Max specs.?The 11.0 Vdc, is just to make the radio run

A lot of information, thank you Rob. Looks like the replacement board will not solve my problem. I have been through the radio's belly and couldn't find anything visually. I never use more than 3

Thanks and sorry I didn't see it. 73, Ae7YD

It's linked to the first post. Otherwise here's the direct link: https://github.com/wicknix/x6100_gui/releases Cheers

The package being sold on Alibaba only contains the Baseboard BPF/Codec/PA/DC-DC//ADC, which is basically the radio and battery management section. Most of the problems are in the Baseboard. This

Jens, can you share the link? Thanks.

I agree with you Rob, as I have been burned several times buying used radios. I did blame my bad luck and Murphy's law as it has happen also with brand new radios purchased from official sellers? but

Followed directions and now all good. Tnx guys! 73, k8sar

With FW v0.29.2 no adif eQSL upload problems occours. Just tested , sure. Have a nice weekend ... 73 + 76 , Jens / HB9JOI +++ Sent: Saturday, March 29, 2025 7:15 AM To: [email protected]

I don't see any issues with this file. Did you try to upload it with form on this ( https://www.eqsl.cc/qslcard/EnterADIF.cfm ) page? -- Georgy // R2RFE

You are right Yvon but please read this: I considered buying another used one to swap parts between them, but then I remembered that my X6100, that I was repairing, was bought from "ePay"; sure it

Not cheap indeed. Might be cheaper to find another used 6100.

Not cheap but there you go: https://www.alibaba.com/product-detail/Xiegu-X6100-Radio-Board_1601269290197.html?spm=a2700.galleryofferlist.normal_offer.d_title.56e013a0vlyvrw 73RobYS1RS

File attached

Likewise – my experiences too – and I upload to LOTW, QRZ, and eQSL w/o any issues. Daniel Baker/ K4DB Sent: Friday, March 28, 2025 8:13 AM To: [email protected] Subject: Re: [xiegu-x6100]

Just did a search on Alibaba and see no such thing. Link?

I use R1CBU for FT8 exclusively and I don't have a problem with eQSL as shown in the screen shot attached.

FT8 app on X6100 can start transmit with not more than 1 (or 1.5) seconds after 15 seconds time slot started otherwise generating and transmitting message might exceed slot. Also FT8 decoding support