开云体育

You can use either the ext or int?battery for x6100 operations xmt and rcv. Just with int battery get 5 w output. With ext get 10w.? Also can charge int battery using external battery but do not

Hello everyone ! My name is Luis LU4HK. Something happened with my Xiegu X6100, when I connected the USB something exploded inside. Does anyone have information on what could have happened? It's been

*That would be good.* *No it defaults back to the saved band outside the FT8 app* -- Gregg W9DHI, ORC Webmaster and CTO

New to this radio, pardon me if this question is clarified elsewhere... but I haven't found the answer in the documentation or in group threads... Just so I'm getting this straight. DO *NOT* use the

Hmmm. I guess it might be tricky. There are no free encoder to bind this function to it. Also, pressing on VOL encoder behaves like escape. Perhaps, I'll find a way how to control it in a handy way

Hi John. Current implementation uses 1-9 buttons as a load memory (with a short press) or save memory (with a long press). I guess, I can assign same behavior to a dot (.) button, but it will behaves

It would be nice if the RF power could be adjusted without leaving the APPs of FT8 ect.? ?When I switch bands I need to change power level for amplifier.? On the lower bands 0.5 watts is enough

Hi Georgy Is it possible to have the Mic Button marked 50 to be programed to select the 6m band please? 73

Hello, My CW decoder was working fine: decoding the station I was working immediately after I TX'd. Now, for some reason, it takes a lot of time to read what the other station is CWing. Any

Thank you, Rainer, I thought that was a possibility, but the names do not lead you to that conclusion and the manual is less than helpful in explaining. Take Care, Dan

Thanks you Ranier for the answer I did try with AGC A/S/F and it is actually worst, I have use the Radio twice. I notice yesterday on a Pota Activation, I had hell of a time trying to get the Call

AGC is off, try "AGC Auto". The switching transient during release of the PTT is the culprit. Greetings, Rainer DG1SMD

Dan, those are the audio ports of the internal soundcard (C-Media CM108). There is also a USB-to-UART Bridge (WCH CH342) and a USB hub. (USB Device port, the Allwinner R16 SoC is connected to the

X6100 on 10m with a Dummy load noise level is at S3 is I press PPT when I let go Noise level jump to S6 to S9 for a second them goes back to S3 is that normal? I have add a video is this normal I have

Under the radio settings I see entrees for LINE IN LV and LINE OUT LV.? Can someone tell me what these settings impact?? As far as I can tell there is no line level input connector.? Does the S/P

Thanks for you help I got it taking care... 73 KQ4WGS [email protected]> wrote: -- Nemury Valladares

It's issue of the ft8lib. I'll try to fix in one of the next release. -- Georgy // R2RFE

ALC shows only when ALC magnification turned on in settings. -- Georgy // R2RFE

Have you tried it with shorter suffixes?? I know adding /P works for me.

I decided to go ahead and post the corrected frequency response plots here. The ripple was completely pilot error. It turns out that the X6100 TX image rejection is not so great.? For my