开云体育

Mmmh I don‘t See a difference in rx sensitivity, I‘m happy with app 1.1.9 and base 1.18 Von meinem iPhone gesendet Am 23.09.2024 um 12:04 schrieb Bjorn SM0MDG via groups.io

... that`s no solution , Joao. Sorry ... Sent: Monday, September 23, 2024 9:41 AM To: [email protected] Subject: Re: [xiegu-x6100] Xiegu X6100 Firmware Update v1.1.9 (2024-09-15) For now just run

What does “such nonsense with like with 1.1.9” mean? Has anyone done measurements of MDS supporting loss of sensitivity? I can see the logic in this fix, and personally I think the RX sounds much

Thats on APP FW, so unfortunately those do not seem to be working as they should on APP FW 1.1.9. But my guess is that you allready knew that. :-) I don't really use them, and I favour the larger

Does CW / RTTY work with this combo?

Sell, iam using it with ft8 and ssb- no Problem Von meinem iPhone gesendet Am 23.09.2024 um 09:41 schrieb CT2HME via groups.io <joao.cunha.lopes@...>: ? For now just run App at 1.1.9

For now just run App at 1.1.9 and base at 1.1.6. And you can also keep a few BASEs FW available so that you can switch for testing/usage. Switching requires 30 seconds, maybe less. At this point in

In my honest opinion V1.9 is broken... Worse still it is broken in a way that has broken a lot of useable features but it looks like it's working OK when it is not. This is a terrible update :( de

I can confirm this report . After some hours let running only FT8 receiving ... the scope is getting slower and slower til it is complete frozen after some hours . And Georgy , I have measured with

Well, I don't run application so long. It might be few places, I'll check. Thanks for your feedback.

Antenna is properly tuned for bands I work on. My base IC-7410M works perfectly fine with it. Also the antenna is EFHW, and like I said, before I tried swr sweeping with calibration load it all was

Done. Sent: Monday, September 23, 2024 6:25 AM To: [email protected] Subject: Re: [xiegu-x6100] Xiegu X6100 Firmware Update v1.1.9 (2024-09-15) Ok Joao , very good idea. Thanks for the link . I

Ok Joao , very good idea. Thanks for the link . I will post that to them , ofcourse . Because – I think ... - we all want back a sensitive receiver performance , not such nonsense like wit 1.1.9.

Jim, This is what Ct2hme was talking about ?73, Steve

Joao, thanks. I had just figured it out and got it working myself when I got your message. My problem was the USB connection now brings up 2 com ports instead of one. Besides the new A4 address, I had

Jens (HB9JOI) and Scot (M0RWV), amazing stuff listing everything that isn't working. If you haven't, I suggest you guys also report this to Xiegu via Radioditty. Here's a link to report problems and

Jim, please try this thread, where I posted a print of a N3FJP working config. /g/xiegu-x6100/topic/108341012#msg5861 Try ICOM2, use A4 on both commands and change your Power Option

The Icom Mic has exactly the same outside case but totally different electronics inside. <john.brent@...> wrote:

Did that, still doesn’t work.

Janis, change the 70 on both sides to A4 ?73, Steve