开云体育

I can confirm this report . After some hours let running only FT8 receiving ... the scope is getting slower and slower til it is complete frozen after some hours . And Georgy , I have measured with

Well, I don't run application so long. It might be few places, I'll check. Thanks for your feedback.

Antenna is properly tuned for bands I work on. My base IC-7410M works perfectly fine with it. Also the antenna is EFHW, and like I said, before I tried swr sweeping with calibration load it all was

Done. Sent: Monday, September 23, 2024 6:25 AM To: [email protected] Subject: Re: [xiegu-x6100] Xiegu X6100 Firmware Update v1.1.9 (2024-09-15) Ok Joao , very good idea. Thanks for the link . I

Ok Joao , very good idea. Thanks for the link . I will post that to them , ofcourse . Because – I think ... - we all want back a sensitive receiver performance , not such nonsense like wit 1.1.9.

Jim, This is what Ct2hme was talking about ?73, Steve

Joao, thanks. I had just figured it out and got it working myself when I got your message. My problem was the USB connection now brings up 2 com ports instead of one. Besides the new A4 address, I had

Jens (HB9JOI) and Scot (M0RWV), amazing stuff listing everything that isn't working. If you haven't, I suggest you guys also report this to Xiegu via Radioditty. Here's a link to report problems and

Jim, please try this thread, where I posted a print of a N3FJP working config. /g/xiegu-x6100/topic/108341012#msg5861 Try ICOM2, use A4 on both commands and change your Power Option

The Icom Mic has exactly the same outside case but totally different electronics inside. <john.brent@...> wrote:

Did that, still doesn’t work.

Janis, change the 70 on both sides to A4 ?73, Steve

Jim, change the 70 in the string to A4 on both sides in Aclog ?73, Steve

Did you swap the cords as well? Not sure if all the functions on an icom mic work on this radio.

The mic it came with (i bought second hand) did not function properly, only the PTT and lights worked. I swapped it out for an other Icom Mic, it also functions in this same way. Anyone have some

If the radio sees very high swr, it will protect it's self by not transmitting. You need to tune your antenna to be able to transmit.

Janos, This is the setup I used with N3FJP's AC Log for V 1.1.16: In both the Read Frequency and Read Mode commands, the hex 70 is the rig's Identification number. Xiegu X6100 setup for N3FJP Logger

Janos, it doesn't use CI-V, it uses a serial COM port via USB.? I have the correct driver and everything installed, it just will not talk to the radio via the COM port it says the radio has.? The

Janos, sensitivity is just fine. ?Did not notice any changes with or without preamp in mine. ?Made a bunch of good CW QSO’s on 20 this morning after the upgrade. ?Just couldn’t autolog them.

Hi Jim, Just some additional questions: are you on the latest APP and Basis firmware? If yes, I am curious if receiver sensitivity is OK, I read some bas reports about it here, 73, Janos ON4JBS