开云体育

Yes - see new topic posted today referencing 1.1.19.

... and what is with this issue in v1.1.9 : ... has til now nobody noticed that in App.1.1.8 in the audio scope the courser in CW is not on the PITCH frequency, but much too high, completely off the

There is a 1.1.19?? Sent from my iPhone.

Installed with no problems. Just started testing. The new colors are finally here, much better to read on field. They ditched red and are now using white. Finally. Great to see Xiegu listening to

With the release of 1.19 with base of 1.18, I'm assuming we should not apply these patches yet?

Also - be sure your SSID does not contain spaces.? It will fail.

Hi, v1.1.9 resolved the inoperative TX RF output issue occurring with my x6100 and initial test results are very good. NQ4Y

Xiegu X6100 Firmware Update v1.1.9 (2024-09-15) *NOTICE* : The v1.1.8-240904002 update was withdrawn on request by Xiegu. If you have updated your X6100 and experience TX failure issues, this update

Go a few questions in private email, to clarify a little; This update is received directly from Xiegu tech department. The previous version 1.1.8 was not fully compatible with some of the hardware

Thanks Georgy, sounded cut off like an older telephone capsule microphone ;) now like it has to be! Xiegu always makes there radios worser than they are due to dilligence. Not only in the software,

The new FW v1.1.9 from Xiegu with fix for the TX issue is available from Xiegu.eu. On our request the color scheme has also been updated for better visibility, now white text on blue

Hi Testes yesterday the 0.2.4 Firmware. Had it Running whole afternoon in ft8 Mode receiving, when Train to Switch back to normal Mode aft er some Hours, the Display was frozen, vfo functioned. To

After success connection to WiFi you will see: * DISCONNECT label for button * connected text on your wifi item. Also, you can try to turn on DHCP (like on picture). Then use name xiegu-X6100 instead

... also if I`m with both (Computer & X6100 ) directly located at the router ... and in the same network I get no access to the X6100 . All entries are correct in WinSCP (or FilZilla too), but the

I created a version with fix: 0.24.1 https://github.com/gdyuldin/x6100_gui/releases/tag/v0.24.1 All dependencies was on their places, but order of building was wrong.

Yes, I used https://github.com/fventuri/BBFW to decompile, than find similar place in 1.1.7 and patch it. Don't forget to decrypt before comparing.

Easy to install Gregory and worked perfectly. Nice low response and I think it improves the built in microphone response but maybe it's my imagination (but I dont think so, the internal mic seems more

Awesome! Sorry for quick reply I’m on mobile but this is awesome! I’m guessing you found the hex address for the passband filter limits? If so I can hex compare your version to the original and

Absolutely correct.

This firmware is independent from the R1CBU. Using R1CBU will not change BASE firmware. Also - this patch might be used with original and R1CBU. It's just for another part of the radio.