开云体育

new? https://www.youtube.com/watch?v=C6sbH75b04A

hi please watch this https://youtu.be/_fj93Eqe60g?si=JSd_Rbol7c7Fba5 73 DE muhsin TA1MHS

... has til now nobody noticed that in App.1.1.8 in the audio scope the courser in CW is not on the PITCH frequency, but much too high, completely off the mark...!!?? The audio scope is absolutely

I agree with this. The gain is now as it should be - at 100% the gain is "100%" and anything less is attenuation... That is perfect behaviour and the RX is sensitive and lovely. Combined with the

I found a problem with the CW messages. Sometimes it would play incorrectly, missing elements and being generally undecipherable. Going out and back into message play at least temporarily fixed it.

It looks to me like power output is now being shown in the same field where received signal strength is shown when receiving.? When I key up it changes to a scale of 1 to 10 and the values shown are

My waterfall is lackluster and needs pumping up a notch or two. I’m guessing that altering either the receiver’s effective sensitivity (or other measurable real world receiving adjustment, e.g.

I don’t know why you all don’t realize that the firmware change notice said that the gain was changed. Yes previously, rfg of 63 resulted in a calibrated S-meter i.e. - 73dBm is S9. Now rfg of 100

On Sun, Sep 8, 2024 at 02:37 PM, CT2HME wrote: > > Yup, same here: App 1.1.8 and Base 1.1.6, white mod done, working amazing. > > --> here is an interesting data point, with App and Base 1.1.6 my

Many thanks [email protected]> wrote:

It's basically the same process. Here's how mine looks right now. 73. Joao, CT2HME

I tried out the ver .23. All was well but the volume only goes up to 55. Any ideas?

Is the white text mod the process that was developed a couple of years ago or is it now a new process. If its the old one I must try and find how I once did it. If it is a new process any chance of a

James I assume, with 1.1.8 and 1.1.6 base, the ALC and RX dB level are still not displayed. Am I correct? [email protected]> wrote:

You actually need to use the "A4" on the new FW commands. Past FW versions did not care about the CI-V address, whatever one was beeing used. Glad its working. Have fun. 73. Joao, CT2HME

Joao, Wow! Its working now. Tried everything but Icom2. Your attachment showed me where to change setting and it is working now. Thanks again. ?73, Steve

Yup, same here: App 1.1.8 and Base 1.1.6, white mod done, working amazing. 73. Joao, CT2HME

Hi. Try the following (notice the "A4" in the commands.), and let us know if it works. 73. Joao, CT2HME

Hi , no I do not know this programme, But the cat control C I V address has now been changed to A4, Good luck Dave 2E0DMB wrote:

Anyone using N3FJP log software? What radio settings are you using? Trying them all and no luck. Thanks