开云体育

The APP firmware the one that you see erasing and loading. There is no visual feedback on the Base upgrade which occurs after system/upgrade button pushed (except a perecentage).

It should have written? to the flash memory in the STM32. It does say Erasing Flash when you see the process working ?.? Think there are some You Tube videos that show this.

So when you do a x6100 firmware upgrade, the radio starts and a screen dialog tells you what's happening and automatically shuts down.? So at this point what has been written to where ?.? Then you

Simon?? via ST software could you not load a demo file to the STM32.If that loads ok.Then try to load the X6100 firmware. I thought there was an option to zero the STM32. Using ST-Link. This may be

Just to show how much I love this firmware.? Here's my uploads to log since December 2nd when I started using it

Thank you Very useful

Hi JJ, Thanks for the reply. I think I may be in the same boat with a blown chip. I’m in NZ. Where did you source the new mother board ? Thanks Simon Jones <mailto:simon@...>

I just repaired a 6100 with the same issue and it was a bad STM32 chip. I ended up swapping the main board for the customer. JJ W9JES Radio & Electronics

Never knew the FM was quiet until this thread as I have not yet used it. It was indeed quiet. Tried the updated firmware. Works perfect. Nice loud volume without over deviating. Great job

Try to keep it short.? Bought a radio with duff encoder, 6 pin FFC connector badly damaged by a previous owner. Sent tiny board away to a guy to replace the connector so could then fault find with a

Have somehow corrupted my base software. Display shows but radio is dead. Have tried re-installing various firmware versions no good. Thanks for any suggestions

Hi Georgy. Thank you! I’ll test that change soon and let you know if it changed anything. In the meantime I’m playing with creating raspbian image for x6100 with Vara modem and PAT instance, to

Thanks I am on the ‘Silly Step’ I had plugged in the control cable to my XPA250B which seems to have caused a data issue. Once I unplugged the lead all worked fine. A whole day playing

I had a similar problem. The X6100 is sensitive to SWR and will reduce power a lot if SWR is over 2. To be 100% sure the ATU is locked in do the following. Make sure TX CQ and TX call are

OK - following on from the FT8 questions.. For some reason, since this morning, I have not been able to get more that 2w out on FT8 / FT4 and when tuning the ATU. I have tried updating the X6100's

Mine works but will only transmit at 2w and there’s no Reducing Power to 5w message

Does it transmit at all?? SSB?? AM? CW?

The same thing just happened to me this evening. I'll be following this thread for sure.

I found a value to adjust FM modulation level. In attached base firmware it's increased 3 times. Hope it will be enough. -- Georgy // R2RFE

There is a discussion about saving/restoring settings on the github: https://github.com/gdyuldin/x6100_gui/discussions/20 -- Georgy // R2RFE