开云体育

[email protected]> escribió:

With the x6100,I use the 20ah battery from my go box with a 9vdc output dc/ dc inverter. Pulls 10 watts with no problem with 9vdc. Just remember to turn off charger in radio. ?73, Steve

These just fit across the back of the radio: https://www.amazon.com/dp/B0948TKWLS?ref=ppx_yo2ov_dt_b_fed_asin_title Radio has been on for hours, and it's still just warm to the

i found the back of my 6100 was slightly bowed (if i put a ruler top-bottom on back there was about a 1mm gap in the middle) so i uesd 20mm x 20mm x 10mm heatsinks and works realy well i also

Could you send link to what you got?

Also, I seen a recommendation to reduce power voltage to 10-11v. It should be still enough even for 10W output, but with less heat. I bought DC->DC converter, but still not check it.

I saw a post a day or two ago where someone posted a link to a pair of stick on heat sinks on Amazon. I bought a set, they fit perfectly and work great. ? The radio is staying just warm to the touch

Thanks for the comments – I tried to transmit but there was no output on any modes. I then re-booted the rig into its native firmware with still no output. I then reset the X6100 to factory settings

Well, radio was switched to TX. I saw the same behaviour a few times. It might be a bug in the BASE firmware or a main to base communication issue, not sure. Did someone see such behaviour using

Niall, Update on SD card. Replaced SD card with a SanDisk industrial 10. Changes frequencies faster now. Thanks for the suggestion and explanation. 73 and have a good weekend. ?73, Steve K8SAS

Hi I am experiencing lock-ups. GPS and Wi-Fi time both working properly This happens when I leave the radio switch on when receiving FT8 / FT4 signals After a while the sound mutes, the red power

Thanks Niall, Never gave that a thought. Will try a new faster card. Thanks ?73, Steve

Hi, I suppose it has to read parms.db to find out what the next/previous band is. Maybe a faster sd card would help. The factory firmware doesn't have to read the ssd card, it probably has faster

Updated R1CBU to .26 FW. I noticed that the up/down frequency buttons on top are slow to change bands. Any ideas?

Yes an no Plug it in. no configuration.

Am I right... I can just plug in one of my little usb GPS modules and have the radio set the time from that? ? Do I need to configure anything? -- Stephen AC2GW

Yes, I use the external GPS, and it is my preferred way (looking forward to use the WiFi option also). Just saying the TimeSync was an added value in some cases, like: - inside a building, or even

That's how I do it.

Hi, As an experiment,?I made a printed circuit board for a simplified (PTT-only) microphone and also a 3D-printed case for it. I built a few and they work although I have to turn the mic gain up a

What about setting time from GPS?