开云体育

Franco, i have rebuild the Kernel and was able to make a? FT8 QSO. So i think FT8 works now. Again, thanks for your and all the others Work to make the x6100 better. ? 73 de Markus, DB2ZW

Ah thanks I got you done and working 73 KQ4WGS Nemury Valladares [email protected]> wrote:

Under the Gen button, Volume page 3 - last button on the right is MONI - turn it down to zero.

I am sorry for my bluntness but what do you mean by turn off the monitor 73 KQ4WGS

Turn off the monitor.

I am having some terrible issues when I Key the mic it come out form the speaker high pitch any help would be appreciate I am loving this firmware. 73 KQ4WGS

Turns out that the problem with FT8 TX not sending out any signal was due to this line in the sun8i codec module in the Linux kernel:

Did you ever find a solution to this? I have the same error. Side note: FT8 WSJT-X works 73

I've always heard the tale as starting with a stone rather than an axe, but so applicable in many contexts! I have been known to relay that story when discussing feature creep with new in career

There is a tale about a soldier who cooked porridge from an axe (; If you take X6100, remove STM32, replace AllWinner with FPGA, rewrite DSP functions, open the source code - you will get TRX "Brass"

On Fri, Dec 27, 2024 at 10:47 PM, Georgy Dyuldin wrote: > > > As far as I remember, biquad filter is used there. I'm not 100% sure, but > looks like coefficients are precomputed (stored as a values

I initially thought so as well. ?I did measure the function generator, and it was extremely flat. But after looking at several runs of the test using different drive levels, you can see that the

It might be due to digital filter design on the firmware. At least, when I recorded signals - they all have some audible resonance close to cut-off frequency for any frequency from 160,200, 250, 300

I found a 10uF tantalum cap I used as a DC block.? The 0.18uF I used previously was introducing some additional roll off.? I also changed to acquisition code to actually look at the FFT bin that has

Thanks for this!? I am planning on connecting a nice microphone and footswitch to the X6100 and started doing some testing.? I noticed the 300Hz lower limit on the audio and searched to see if that

Watch out for those balls !? re the leg that is ....mine does not have any so going to order, size is 2.38mm. Now? Possibly the best firmware/base version thread ?Joao, CT2HME?? the screen shot

Hi Keith. Yes, external power. Warming up to taking it apart, watched a few repair videos so know what to expect.Simon??0275482833

That's right you don't? get much confirmation of what's going on. Has the radio ever been apart. And you are doing the fw upgrade with external psu,say 13.8v connected. Are you happy enough? to take

The APP firmware the one that you see erasing and loading. There is no visual feedback on the Base upgrade which occurs after system/upgrade button pushed (except a perecentage).

It should have written? to the flash memory in the STM32. It does say Erasing Flash when you see the process working ?.? Think there are some You Tube videos that show this.