开云体育

I have the same problem, it keeps calling for ever. Love the software.

I had the same situation with my 6100. I had it for a few months but only used the receiver. Once I started trying to transmit with it I found no output, all bands, all modes. I worked with my dealer

Thanks, no I hadn't tried... but both in ON and OFF the same problem happens as before. 73 Mauro

Hi. I was busy by porting this firmware to X6200 (almost finished) and implementing a compressor within X6100 BASE firmware (unsuccessful yet). I hope I'll finish these tasks and return to the X6100

K8SAS, Nice find - ordered and set it up with powerpole input and a dc plug output for the X6100. So far working great. Thanks.

It's been mentioned before. Can you look at introducing a time out on failed calls ? Sometimes my Xiegu replies to a stations call but does not necessarily finish the contact - as a resut it sits

Hi Mauro, you don’t tell us how was your Charger option on or off during your tests. Maybe that could influence your issue. 73 Ben

Hi, it happens to me that the X6100 gives a very short "hit" of transmission and then does not emit anything. I specify, I give a call in CW (I use mostly CW but in SSB it is the same thing). I see

Why bother?? Just use R1CBU version with built in FT8.

Hi Brian. So far it’s impossible using internal Bluetooth. I’ve successfully connected mine using USB cable instead 73 de SP9HGN W dniu czw., 3 kwi 2025 o 16:49 Brian K0HBL via groups.io

Has anyone had success connecting your X6100 to your Android device via bluetooth in the FT8CN app?? I am able to connect the radio to my device via bluetooth successfully, but not getting any data

Yvon, how do you like the Hermes Lite 2, and how well does the MicroPA50+ work with it? I sometimes use a MicroPA50 (no plus) in the field and love it. I did the resistor mod to increase the SWR

I use a 12ah battery connected to the X6100. It only takes 9 VDC to acquire 10 watts out. So I use

in the shack I am using a Powerwerx for my Hermes Lite 2 with a MicroPa50+ and a SamlexPower SCP-1235M for all my other QRP radios. The Samlex was factory set to 13.9 volts, now? I did adjust it to

Thank you, I did order one.

Thanks, I did order one. Should be here tomorrow.

I agree with Roberto. Also, I believe that the X6100’s TX power comes down with reduced input voltage. I’ve found two things to help: 1. Light, portable/rugged voltage converter, suitable for

Might want to look at digipi - think he did this already. https://craiger.org/digipi/

I'll take a look a bit later. If you familiar with ghidra - you can try to find corresponding place in code using attached files as a guildeline (for 1.1.8) -- Georgy // R2RFE

Would it be too much to ask if you could do this for base 1.1.6_160 also? Thanks.