I had the same problem with my x6100 after an upgrade. I charged it, run it down to dead 4 times and that seemed to have fixed it. I now have a full battery charge showing when charged.?
Bobbi
K4ARY
Sent from Proton Mail for iOS
On Sat, Aug 5, 2023 at 6:44 PM, David Shelton <
des.n4in@...> wrote:
George,
Sorry you are having problems with the X6100, I have a used unit that I have been using for about 2 months, you are welcome to borrow it and see if it works differently that your unit and use for awhile.
73,
Dave N4IN
Thanks for all the info from everyone.
Several items to note:
1. Discharge to shut off is about 2 hours.
2. Charging source is 13v 25A PS . (Anderson Power Pole connection)
3. MicroSD is "Micro Center" Class 10 (was brand new)
4. As for Firmware, I followed instructions included with Firmware Pack and did the Base Band.
I can try again. but the firmware shown in attached picture looks to be the most current.
Could someone compare with what is running on their x6100?
5. I am currently recharging with OEM Charger and will retest.
Again, I am not seeing the light EVER in the solid on state, always blinking here.
..73
George N2GWK
--
73,
Des, N4IN
K4ARY