It triggers on any input data if all are left unselected. I guess I was hoping for some sort of way for it to read only when a certain condition is met instead of looking for a one shot trigger that sends it running until it times out.?
Since you said using CE as a low trigger didnt work, I guess I should have asked what is the source for the simple trigger than is giving you results.
I'm guessing you see those options when selecting CE as a trigger?
If there is a trigger configuration option for passively pulled up or pulled down, you could try pulled up and feed the trigger input from the CE line thru a .01 cap to generate a pulse.
Also adjusting the threshhold may yield some results too, but if the CE never toggles (no read initiated) it wont trigger anyway.
Put a second mode in, set NP scan and I bet rhw CE line goes nuts.
?
