开云体育

ctrl + shift + ? for shortcuts
© 2025 开云体育
  1. X25
  2. Messages
Single Messages Topics Expanded

Re: Getting started

 

开云体育

The quickest start for me was to clone and build xotpad from here:


Then, you can try out calling some x.25 hosts per the community doc here:


If you are eager to see the protocol, wireshark will dissect it.

Also in that doc are some Cisco IOS configuration examples.

You don’t actually need to use the serial interface at all to get started. ?You could configure the Cisco Ethernet with dhcp or static, then with the x25 route that specifies xot (search for x25 route) in that doc, you could just use the x28 pad in the Cisco to make your calls. ?The command to get into the pad, as I recall is “x28”.

One destination from that doc that has been working recently is “40400201”.

Regards,

? Phil

On Sep 18, 2023, at 8:00?PM, justapersom@... wrote:

?I dont have a WIC-2A/S but I do have a WIC-1T. Of course without the cables but, maybe I will buy some in the future. Could I use the WIC-1AM-V2 and WIC-1T together? Also I dont think I have a machine with a synchronous serial interface, I didnt know I needed one.

Join [email protected] to automatically receive all group messages.