开云体育

Hi friends -
I must say: fldigi works a charm on my (radio-exclusive) AMD pc with W-
XP SP3 through navigator interface with a FT-897. No problems
whichoever. Installed it, fiddled around a bit, discovered which
settings it needed, and it is in daily use now.
My question is: has anybody heard about the FT-2000.xml being written
or published by someone else? The problem is not that fldigi would not
work with it. To the contrary, also here through the navigator and TTY-
PTT it is usable, though without the additional QRG-indication etc.
When trying e.g. the FT-1000.xml the result was nonsense and fldigi
said "byebye". I had to manually edit the fldigi.prefs to get rid of
entries I did not want.
I looked into the CAT-handbook for the FT-2000 with all required syntax
but got no clue how those xml files are construed. Therefore I would
welcome any hint.
73 Fred DL6XAZ

I have uploaded the explanation of the rig.xml to the files section of
this group. I hope it will be enough to get you started. Remember to
change the com port designation and baud rate to match your set up
when working with existing xml files of similar equipment. Most of
these were originated and tested on Linux but should be fine.

Rich
WA4SXZ

Rich - that is very kind and once the grey cells have digested the
most important points, I think I shall have a go. Problem is that I
never dealt with such syntax as - lazy me - I always used what was at
hand without giving it other thoughts.
If I get to any useful result I shall publish them here (but I guess
it will take its time, hihi...)
Thanks again
vy 73 Fred DL6XAZ



--- In win-fldigi@..., "rich" <richwa4sxz@...> wrote:

I have uploaded the explanation of the rig.xml to the files section

of

this group. I hope it will be enough to get you started. Remember

to

change the com port designation and baud rate to match your set up
when working with existing xml files of similar equipment. Most of
these were originated and tested on Linux but should be fine.

Rich
WA4SXZ

--- In win-fldigi@..., "Fred" <dl6xaz@> wrote:

Hi friends -
I must say: fldigi works a charm on my (radio-exclusive) AMD pc

with W-

XP SP3 through navigator interface with a FT-897. No problems
whichoever. Installed it, fiddled around a bit, discovered which
settings it needed, and it is in daily use now.
My question is: has anybody heard about the FT-2000.xml being

written

or published by someone else? The problem is not that fldigi

would not

work with it. To the contrary, also here through the navigator

and TTY-

PTT it is usable, though without the additional QRG-indication

etc.

When trying e.g. the FT-1000.xml the result was nonsense and

fldigi

said "byebye". I had to manually edit the fldigi.prefs to get rid

of

entries I did not want.
I looked into the CAT-handbook for the FT-2000 with all required

syntax

but got no clue how those xml files are construed. Therefore I

would

welcome any hint.
73 Fred DL6XAZ