开云体育

Does anyone know if a transmission floor cover off a cj- will fit a 48 willys pickup? On Thu, May 6, 2021 at 10:51 AM, Ted McCann<mccannrealty@...> wrote: Thanks for posting about Willys

Thanks for posting about Willys truck warehouse, never knew it existed. Need some body work done on my ‘59. Hopefully they do good work and are good to deal with. Ted

Just to circle back… Had a ton of work just done with transmission and transfer case. Turns out the both the $%$*#!@ mechanics that worked on it previously were more tinker toy scam mechanics than

If I was closer and not warming up for spring planting, I'd be there......the life of farming.... Landen Schooler Ps, I was reading my email in reverse order... I see now you're in Idaho... Sent

You may want to tell where you and the OHC6-230 is located?? Landen Schooler

In kellogg idaho, about an hour east of Spokane wa.

Hi Jay - where are you located?

Skip, there is a shop in Santa Fe NM that could dl that I think, but it would not be cheap. If you need a phone number I can get you one. Pruit

Just throwing this out there, I have a 230 out of a 1962 wagon. I did a light rebuild on it several years ago and it has since sat in the garage under cover. Carb will need rebuilt and I have bell

The pickup is in Colorado Springs, CO. No if's and or but's, it will need to be rebuilt. Compression has dropped on all six cylinders and there's no power. I would agree w Pruitt, when I rebuilt it I

Find a long established forklift company because older forklifts use the exact same Continental engine.....

When I was running the 327 in Tinkertoy I pulled the heads after around 75,000 miles and found one exhaust seat hammered about 3/16" into the head. I replaced all the exhaust valves as well as intake

It depends. If the engine has been run on leaded gas and the seats are not cut, there is enough lead embedded to continue running a lot of miles on unleaded gas, But, if one cuts the seats during a

Pruitt, Agree on the high zinc oils for flat tappets....a must have. However, I don't agree on the hardened valve seats. I have several vintage car engines that are doing just fine on their engines I

i don't know where you are located, but if it's anywhere near southern nj i know of a place that can do a flathead 226 rebuildwell and i thought his prices were reasonable.? did mine 4-5 years ago

Most likely you will need to have yours rebuilt. It should have hardened valve seats if you did not install them last time. That procedure may be a problem with valve in block engines. Maybe

Don't know where you are located. In the midwest, Jasper Engines has a good reputation for remanufactured engines. Expensive but have a good warranty. If they can do it you will likely need to ship

Guys, It's been a while since I've logged into the group - my bad. I've got a '61 pickup with the 226 that I rebuilt many moons ago. This winter I finally started having issues with the motor itself.

On Amazon prime, there is a 1995 movie called "Three Wishes". There's a 2 WD wagon used by the family, sounds and looks stock, same colors as the one I rode around in when I was small. Recommended

Ok cool… Thanks Gents! Slowly bring this old girl back to her glory days.. Checking with my mechanic now… but it almost makes more sense to just replace it since everything has to