开云体育

Looking for help on where to locate auto reverse units on this track plan. Not sure how to attack this. Uploaded track Plan to a folder named " New Track Plan 26jan25" Thanks for taking a

The system is a complete standalone mini DCC system Tom in Texas

Tom, That's good to hear.? Does it have a booster of some sort built into it drive a locomotive?? Or do you have a booster or DCC system with it? Thanks! Allan

I installed one of the Motorman units for a trolley run on one of my friend’s layouts. The programming is straightforward, and the unit seem to be reliable. Tom Pearson Benbrook, Texas

IMHO I am not familiar with the NCE mini panel. I would keep the shay DC and use a standard auto-reverse unit. Circuit.com makes several auto reverse devices. They use opto sensors so do not rely

Martin Gliddon, My gears are already shot — apparently from just a few runs/reversals while we were testing the addition of a DCC decoder to determine whether it would work. It does, but the loco

Allan Gartner, Thanks for the reference. I know better and ought to have gone to your website first for anything DCC! Will be most interested in whether anyone responds to your inquiry about

Scott Haycock, Thanks for the recommendation. Looks right on point. Bill D N&W Steam Only

Thanks Steve. Bill D N&W Steam Only

Hi Bill, If you are going to use the Bachmann Shay, I would recommend that you get the engine to fully stop and pause for a minimum of a couple of seconds before returning it down the track. These

All, A request for a DCC reverser comes up every now and then.? For future reference, note that I have this company (Iowa Scaled Engineering) listed in my Manufacturers webpage.

Bill, Take a look at this: https://www.iascaled.com/store/ModelRailroad/Motorman Scott Haycock

Bill D. writes: "My layout is NCE DCC. I plan a single track segment, separate from the remainder of the layout, serving a coal mining complex. I plan to run a Bachmann Shay upgraded to DCC on

My layout is NCE DCC. I plan a single track segment, separate from the remainder of the layout, serving a coal mining complex. I plan to run a Bachmann Shay upgraded to DCC on the track segment. I

The former employees of All Electronics have formed a new electronic surplus store called Aretronics: https://aretronics.com/ ( https://aretronics.com/ ) I just found out about this new company

It seemed to be a general Bachmann problem, very much like certain Heljan British outline O gauge products. Cheers Martin Mohawk Valley Railroad

Also throw in ho gauge too there just as bad or worse . replaced with nwsl’s gears which did the job.

You’re very welcome Bill. Cheers Martin Mohawk Valley Railroad

Properly maintained and oiled/greased, there is no reason why they shouldn’t last a very long time. Pulling and pushing them along the track kills the nylon gears but even then, the early Spectrum

Martin, Thanks for the warning. Bill D N&W Steam Only