开云体育

I have a layout with blocked sections. I isolated both rails in each section. I am using DCC and will be installing a BD4 to operate signals through an SRC24. Do i need to open 1 rail and make

That is a great idea! Do you recommend a small square of masonite per switch or cover the bottom of the foamboard? I'd prefer a small square if you think Foamnails or gorilla glue will hold.

Brian, I would think a small square of masonite or 1/4" piece of wood should do just fine. Just be careful when putting in your screws. Don't put them in too tight or you will strip the

polyurethane (gorilla glue) and laytex type (liquid nails) construction adhesive for FOAM projects will also stick well to wood & foam. I'd use 1/4 inch plywood as the porous nature of real wood

I just purchased an Atlas turntable with the motor drive unit and I would like to know how to wire it for DCC. Is it done like a wye or a reverse loop? I have a Digitrax reversing loop

Yes, Philip, just wire like a reverse loop using one set of outputs from the PM42. Allan <autumns_ridge@y...> wrote: and or

Steve, I'm not quite sure I am following your question. Maybe I'm not following you as to how you have your railroad wired. I think you are okay with what you have. Here is the URL from my

My problem is that i have a BD4 occupancy detector, which i am trying to use to trigger a DS54. All Blocks run through a Powershield circuit breaker and are all on one booster. the BD4 doesn't

Steve, You have 4 possible areas of failure: 1. The BD4 isn't wired up correctly to the track. I don't see the BD4 manual on Digitrax's website so I can't help you much. I am using BD1s which

I got some answers earlier. I just don't quite get it yet. If anybody can help me again, my DT100 is showing FF on the right hand side of the throttle. This of course, makes it unable to key in a

If you want a detailed answer, you are going to have to wait about a week and half when I have more time. Here is what you need to do. You need to clear the Chief's slots. If my memory serves me

If you need to be stepped through it before I finish exams next week, call Digitrax tech support. Note: Normally, your slots should not get full. Be sure to dispatch your locomotives before

i have a digitrax operating system power on ytacks read 7.5volts x2=15volts.however when i try to run an anologe train on the address 00 the train runs very slowly i have tried dfferent anologe

Tried the Digitrax group maybe someone here has an answer.

Analog engines will run slower on DCC as the did with DC. It is in the nature of the way how analog engines are handled: A part of the DCC signal is stretched either in the positve or ngative part

I have a similar configuration to yours ecxept all my throttles are DT100R or DT100IR and one ancient DT100. I have noticed that when I turn off power (the UP3/5s are powered) that the throttles

Thanks dale i no longer feel alone. This DT 300 pluged into the same up 5 seems to show idle or PS when ever it feels like.i don't know of battery life yet time will tell. Jim

i have set up an infrared system on my lay out . my question to you is when in the tetherless mode with analog train certain functions do not work such as reverse ,emergancy stop. have i done

Peter, I am running Digitrax wireless. I don't have any experience with the IR. However, I can say that in wireless everything works as it should. I can't think of any reasons why IR should be

I have a 4 by 8 layout which I recently converted to DCC. I am using a Digitrax Zephyr System. It initially ran well at first, but then I started getting sporadic response in my engines. I