开云体育

Yes, Philip, just wire like a reverse loop using one set of outputs from the PM42. Allan <autumns_ridge@y...> wrote: and or

I just purchased an Atlas turntable with the motor drive unit and I would like to know how to wire it for DCC. Is it done like a wye or a reverse loop? I have a Digitrax reversing loop

polyurethane (gorilla glue) and laytex type (liquid nails) construction adhesive for FOAM projects will also stick well to wood & foam. I'd use 1/4 inch plywood as the porous nature of real wood

Brian, I would think a small square of masonite or 1/4" piece of wood should do just fine. Just be careful when putting in your screws. Don't put them in too tight or you will strip the

That is a great idea! Do you recommend a small square of masonite per switch or cover the bottom of the foamboard? I'd prefer a small square if you think Foamnails or gorilla glue will hold.

I have a layout with blocked sections. I isolated both rails in each section. I am using DCC and will be installing a BD4 to operate signals through an SRC24. Do i need to open 1 rail and make

Steve, I thought I replied to your message but I don't see it. The link down below does work. I think the site was down at the time you tried it. The SRC8 is definitely a way you can do what you

I posted the dwg April 13. Go to the files section. Look for "Twin coil Memory Relay.doc" DonV

Thanks for your reply , i would like to see a drawing for latching relay if you have one. I purchased an Atlas snap relay but it doesn't seem to be woking as i intended.

Here's the URL for 2-22. http://www.wiringfordcc.com/switches.htm#a14 While I was looking over it, I did a few spelling and grammer fixes.

Thanks Don will dig it out. Jim

Jim McMahon, try MR, November 2000, page 106 DonV

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the WiringForDCC group. File : /Twin Coil Memory Relay.doc Uploaded by :

If you have powered frogs see http://www.wiringfordcc.com/signaling.htm. If you have Tortoise machines use a technique from http://www.wiringfordcc.com/sw_ctl.htm#a15. Or simply use the switches

I too am looking for an answer to this question. I beleive you need to use an SRC8 from team digital which can recieve a message once the turnout is thrown, it in turn sends a message out which

I'm using Ds54, Team Digiatal and CVP for stationary decoders anyone know of a wiring or output device i can use to report out switch postion using LED's. I have slow motion tortoise's and have

Don Vollrath has made a set of drawings showing various configurations of multiple switch machines, diode matrix'ing, multiple control positions, and indicators. These drawings are now on

Brian, Interesting question. I once had a need to glue foam board to a Tuperware lid. The Tuperware is a similar kind of plastic as used in the Rix bracket. It can't be done as far as I can

Curious, What method has anyone had success mounting switches to foamboard? Do you glue Rix switch mounts directly to foamboard or oyther ideas? Thanks, Brian

Yes. You must wire up both rails. There will be a connection diagram supplied with almost every throttle, power pac and DCC system controller.