开云体育

Disagree. TV Hexjuicer can be used as an AR if connected to both rails. But if used only to juice the frog it does not affect the “phase” of the AR segment and works just as it would within a

Isn't the frog juicer just a specialized autoreverse? If so, putting one or more in a track powered by an autoreverser violates the rule of not connecting two to adjacent tracks. I'd suggest you

Hello I have a Yard with 17 turnouts? all using DCC Concepts Cobalt IP Digitial. motors? ?I have a NCE System that run my DCC system. I have dwarf signals on each turnout using NCE Light-its. I am

The frogs within the AR segment should have their own frog juicer or be powered through the servo throwing the points, just as in in a non-AR segment. Bill D N&W Steam Only

In the previous question, I should have specified that I am using Tam Valley frog juicers to power the frogs. I am concerned that there might be interference between the frog juicers and the reverser

This is perhaps an elementary question, but if I have turnouts within a reversing section, should the frogs be powered by the bus or by the reverser?

Michael: check the Berritt-Hill website. They have all of the information you need. I have been using the touch toggle system with servos for many years and the site is complete for all

Touch toggles sound like switches that hold their position. If so, how will they get cleared or released when the next touch toggle is activated? You need something momentary, because you don't want

Hi Michael, I have no experience with this particular board, but since you're into Touch Toggles, you might want to check this out. I'd email Kevin Hunter with your use case and see if his product

Michael, I have similar setup? I am using a NCE System? ?and tortoise machines I have a button board I designed with push buttons that had a Red/Green Led in them? I also I a NCE Mini Panel I

I am building a single ended yard with 16 tracks. One of those routes has nine turnouts that must be set to properly select that route. All turnouts will be powered with Tortoise Switch Machines. I

Yes! The reversing module will be connected to a single booster and will flip the polarity when a short occurs at the gap. You’ll get unpredictable results and otherwise may cause damage if

On another thread I believe I saw a recommendation that a reversing loop and the adjoining reversing loop entry point track should be powered from the same booster. ?Is this correct and what is the

Mel, I have asked this question on the Digitrax IO groups site. I got some feedback, Don, you may have hit on the cause. I think we need to run the LocoNet 'bus' from the source. Thanks for the

Jerry, ?Have you asked that question on the Digitrax Website? ?You should get an official answer from them. ?Mel

Jerry.. no loconet connection means there is no DCC signaling coming in. ie - off line DonV

I posted this to the Digitrax IO Groups also, sorry for the duplication, but I want to ge this in fron of as many eyes as possible. "Here’s a strange problem we have at the Amarillo Railroad Museum.

I'll try it when I have a little more time and let you know. Thanks Vic

Lawrence, I'm glad your problem is solved! It's your railroad. If you're happy with it now, that's fine. But, if you reversed the wiring of blocks 31 through 40, to match that of 10 and 29 you

Thanks to all for the info you have provided me up to now. It turns out that the issue was maybe a dirty pot on the AR1 CURRENT TRIP, but I have adjusted it and there are NO issues any longer. I did