Re: T-25 Wire Staplers
|
Hold the stapler so the bottom rests flat on the wire and not on an angle. That way the hammer of the stapler will not touch the wires. -----Original Message-----
From: <[email protected]> Sent: Aug 8, 2021 4:47 PM To: [email protected] <[email protected]> Subject: Re: [w4dccqa] T-25 Wire Staplers ?
Ken,
If you lighten the pressure on the stapler it will penetrate less. It takes very little practice and you can test with a piece of scrap. If you want a piece of plastic between, put a piece of tape on the wire.
jd
?
On Sunday, August 8, 2021, 12:26:58 PM EDT, Ken Harstine <kharstin@...> wrote:
?
?
I am not seeing any T-25 staples with plastic to prevent shorting if the metal breaks through the insulation.? As long as only one wire is run under them it is not a problem but it seems like it is asking for a problem if two wires run under one staple.? Plastic insulation deforms under pressure and it seems like it would might break through the insulation on occasion and with enough time.
Regards, Ken Harstine ? |
Glenn