开云体育

This issue of the levels not changing below -115 dBm was reported to Erik a while ago. ?It is probably on his bug list and will be fixed in a future firmware release. Roger

Another term for this use is 'panadapter'. 73, Bill. KU8H

It can be done. See /g/tinysa/topic/99810822#12145 73 -Jim NU0C "Bruce Hawkins via groups.io" <ac6dn@...> wrote:

I assume you can use the ultra as spectrum scope (if monitor) for radio. Best regards, Bruce Hawkins - AC6DN. Sent from my Android phone. And from: ac6dn@...

I checked this at 10,150 and 500 MHz. The levels are accurate, with a lower threshold of -115dBm. I took the liberty of correcting two lines in the firmware so that the readings and actual levels were

Yes, this is as expected The actual minimum level depends on the frequency but -115 dBm is in general reachable The difference between -19dBm and -18.5dBm is within the acceptable tolerances. -- For

Hi all! When measuring the level of the built-in generator, I noticed that the lower threshold does not decrease below -115dBm, although the lowest reading is set to -124dBm. Also, the maximum level

There's a great selection of videos here: https://tinysa.org/wiki/pmwiki.php?n=Main.Videos #01 General introduction video #16 Basic introduction #02 First Use #17 Touch Calibration #03 Calibrating the

Yes Yes, many introduction video's on youtube Yes * * -- For more info on the tinySA go to https://tinysa.org/wiki/

But I have many doubts before the purchase .... - But so as soon as I turn it on I don't have to do anything is ready immediately? - Easy to set the 2 and Max frequencies of the range? Is there a

tnx for all .....? there is a *very simply* GUIDE to use and set-up for? NO-Expert ???? 73

See: https://tinysa.org/wiki/pmwiki.php?n=Main.Buying 73, David GM8ARV -- SatSignal Software - Quality software for you Web: https://www.satsignal.eu Email: davidtaylor@... Twitter: @gm8arv

What do you mean exactly by "Spectrum Scope"? The TinySA series displays the frequency exactly as received. Do you mean that you want to monitor the IF output of something (10.7 MHz etc.) but have the

wrote: It is very easy to set the frequency range. You can either set the range and the center frequency, or the lower and upper limits of the frequency range. Sensitivity is good. With a small

hi, i think is better the *ULTRA model* , some questions : 1) where i founf the very "simply"? instructions to set-up in the MENU for have the spectrum anilyzer ?? and to set the min e max frequenzy

Where to buy:?https://tinysa.org/wiki/pmwiki.php?n=Main.Buying

It IS a spectrum scope. There is a setting to be able to show the scan as a waterfall as well as a spectrum monitor. Zack W9SZ wrote:

i am not a expert and i whant to say if the tinySA is possibile used like a *spectrum scope* ? work well and have a good low sensibility ? what is the best and low price to buy this ? tnx 73

I think we have all experienced SD card problems over the years. Sometimes I find reformatting or recovery tools work, but it's still a bit hit and miss if they work. However I have been discovering

I believe my SD card to be good,works fine on my desktop. I have tried multiple cards and formats. The tinySA recognizes the input ( I get the card icon at least ). If I try to load settings I get