开云体育

Hi Erik Thanks for reply regarding C85 - done :-) However, it does not work as expected :-( There is a lot of noise and in some cases it seems like that an AGC increases the sensitivity when there is

It is difficult to tell because part of the procedure is missing, and the resolution of the scanned page is not that good (Groups IO scales it). At first glance, it looks like a voltage output, or

Fine. Was this for TintSA app? Mike N2MS

Please ignore. Wrong group -- Designer of the tinySA For more info go to https://tinysa.org/wiki

I wondered a few days ago about the other message, too. What's this firmware for and where to find? -- Klaus, DL5KV

Erik, I don;t see this release under Index of /tinySA4/DFU The latest is tinySA4_v1.4-196-g1e9c187.bin Mike N2MS

Good day All. I'm trying to restore/align an old FRG7 Com-radio, have a TinySA that have been using as an RF sig gen and a Zeewiie DSO1151g scope that 'should' run past 100Mhz, well lets just say

Hi Juan, Erik added an 'abort' command? in V1.4165 (May2024) : /g/tinysa/topic/106071963#msg16704

Can you update the changelog please - it ends at 1.4-187 Thanks

*Hello there,* *I am using the Tiny SA Ultra+ (ZS-406, firmware 1.4-196) and sending scan and scanraw commands to retrieve spectrum data, however I was wondering* *Is there any way to stop or abort

Do you have a question? -- Designer of the tinySA For more info go to https://tinysa.org/wiki

the level is different because the signal sources are not directly connected to the SA input, but were just near the connector. two signal sources, one with a lower freq. the other with a higher. SPAN

thank you, all the spurs are gone, just in case I cleaned the cable contacts with alcohol. ср, 12 февр. 2025 г., 12:22 Erik Kaashoek via groups.io <erik= [email protected]>:

Shorten C85 close to the audio connector Or use the pin header pin marked PA4 for for 0-3 V output -- Designer of the tinySA For more info go to https://tinysa.org/wiki

Just received my ZS-407 - a very nice little instrument :-) Seems like listening signal on 3,5mm jack is AC ??coupled? Is it possible to change it to DC coupling, so that a constant RF level gives

Is test 12 failing? If so, you can try to reseat the LCD cable -- Designer of the tinySA For more info go to https://tinysa.org/wiki

this problem immediately pops up after testing and remains so., reboot does not help, only reset. calibration goes fine. If you run the test, error 12 comes out, after that this peak remains. until

There are constant complaints here, it is not possible to rotate the picture from the mobile app, sorry. ср, 12 февр. 2025 г., 11:21 Святослав Маханьков via groups.io

There is a problem with this firmware. вт, 11 февр. 2025 г., 20:11 Erik Kaashoek via groups.io <erik= [email protected]>:

Tnx " It now goes up to 30,522 and interestingly, it works. I tested it at 24 and it sees a signal, I don't need it any further, but it probably works up to 30. Thanks for the