开云体育

Since I don't always have access to the nice test equipment from work I decided to come up with something else to generate the 5.34Ghz signal for calibration. I use a cheap Chinese source that goes to

RBW set to 100kHz and FM sounds great. 30 was not good.

Erik, the frequency is more accurate than I ever expected (I didn't see an error to 5 decimal places even on 5th harmonic). Very good, thanks also to your firmware!

Any findings from the test? -- For more info on the tinySA go to https://tinysa.org/wiki/

Hi,?as promised, I did some frequency accuracy measurements on the TinySA ULTRA today. I used the latest firmware v1.4-8, SA calibrated to 800 MHz, no frequency corrections, span 20 MHz, RBW and VBW

In the interests of efficiency, may I politely suggest that anyone wishing to use Vitor's SW send their System Code *directly* to Vitor rather than to the whole group, otherwise I anticipate a lot of

Vitor. I would like to try your software. my code: FFC96E092362 Thank you for letting us experience it.

My system code is 7F58589E09FE Thanks in advance Andy G4HUE

Hi. Thank you very much, that seems to have solved my problems. All test has passed now, Level Cal, and self-test, and the scale is "normal" again. I am very happy that you had the time to

Seems more like a scaling error, +60dBm from the HW is impossible Can you unplug usb, open the case and unplug the battery, count to ten and reconnect the battery and see if that has made a

Hi. I had already done that, not change. Can it be hardware failure, or do you think it is software failure? /Hans Fra: "Erik Kaashoek" <erik@...> Til: "tinysa" <[email protected]>

Hans, Something is VERY wrong with the configuration of your tinySA Can you try again to do a CONFIG/MORE/CLEAR CONFIG 1234 -- For more info on the tinySA go to https://tinysa.org/wiki/

Indeed, when more than 450 points are asked for it assumes you specified the frequency step Will have a look but I can't break backwards compatibility -- For more info on the tinySA go to

Hi. Here is picture after Preset/load, Level Cal and Self-test. I hopr that is what you asked for. Br. Hans Fra: "Erik Kaashoek" <erik@...> Til: "tinysa" <[email protected]> Sendt:

Can you post a picture of the tinySA screen after PRESET/LOAD STARTUP? And a picture of the failing screen with the "ABOVE FAIL" message? -- For more info on the tinySA go to

Hi. Not the first time, I have done that now, but still same fault. /Hans Fra: "Erik Kaashoek" <erik@...> Til: [email protected] Sendt: tirsdag, 27. december 2022 07:15:48 Emne: Re:

I did not connect the SMA connectors with a cable.? It was a case of user error. Best 73 Mike N9YB

Vitor, I understand from you manual that you do sample the spectrum at the requested points instead of trying to cover all frequencies. If this is true you may consider to use the tinySA hop

Hello, Here is a first version of my software with support for the TinySA Ultra. I attached the manual for the SMA/NWT/D6/LTDZ version of my software, as many concepts are similar - but note that the

Hello Eric, When you issue the scanraw command, the TinySA will sweep the specified frequency range and send back the samples. However, if you select a very big frequency range, for example 100 kHz