开云体育

I have just run another test and it lasted around 30 minutes before the ‘disconnect’ rx: ch> tx: vbat rx : link timeout .. disconnecting A slightly different end (no rx: vbat)

Erik, unfortunately - all this points into the same direction: 39.423 rx: ch> 39.425 tx: scanraw 118000000 136000000 450 39.452 rx: scanraw 118000000 136000000 450 39.780 rx: 1352 bytes

Check the spec of the attenuator -- For more info on the tinySA go to https://tinysa.org/wiki/

But on 146 MHz the attenuation may be different... Mirek Dne 10.12.2022 v 15:16 Erik Kaashoek napsal(a):

Once paused, and window closed, it looks like it goes back to un-paused When the comms window is opened again it resumes to paused Mike G8EII Sent: 10 December 2022 16:13 To:

In my case, after I paused the Comms window, I closed it, assuming that it would stay paused...the App then ran for about 7 minutes before the freeze....maybe I am the 'stupid" one! -- Ed,

Now back to unpaused Tx:vbat Rx:vbat Rx link timeout … disconnecting Regards Mike G8EII Sent: 10 December 2022 16:07 To: [email protected] Subject: Re: [tinysa] TinySA

Please ignore this request, when paused the sweep can not run, stupid me. -- For more info on the tinySA go to https://tinysa.org/wiki/

In my case with TinySA-APP connected to the TinySA (now with firmware V1.3-513), and on continuous sweep, when the USB Comms is paused the TinySA-APP screen is frozen and the TinySA screen is

Erik, The display froze after about 7 minutes and it disconnected shortly thereafter. -- Ed, K0KC k0kc@... http://k0kc.us/

Working on it...will let you? know. -- Ed, K0KC k0kc@... http://k0kc.us/

Can you guys connect tinySA-App, open the VNA comms window (click on the USB symbol) and click on "un-paused" so the text becomes "paused" and try if continuous sweep will still hang? -- For more info

The tinySA is hanging for some reason after the vbat command I will have to find out why -- For more info on the tinySA go to https://tinysa.org/wiki/

yes, “.xó.xS.x#.x#.x?.x?.x#.xc.xC.}ch> vbat last command with no reply - and frozen :-(

I've updated the latest release just a few minutes ago. Can you update and report the value between ()? -- For more info on the tinySA go to https://tinysa.org/wiki/

I installed the 513 this morning. Oh, I think there is anywhere a thing what prevent the display. I switched on the sinysa now, and there is v0.4.5.1 Before powering off a fiew minutes ago ther was

Can you update to the new?v1.3513 FW I just updated and post a photo of the version screen. There should now be a number between () after the HW version identification I need the value of that

Yours is unknown too?

Just put it to charge

It's at my, too. -- Klaus, DL5KV