开云体育

No I did not have any other DFU devices, because if i disconnect the tinySA Ultra it does not see any DFU device when starting the bat file. When the tinySA Ultra is reconnected the bat file again

It seems you had more than on DFU capable device active Make sure the tinySA is the only device connected in DFU mode -- For more info on the tinySA go to https://tinysa.org/wiki/

It looks like I first needed to start the batch file and while it said "Device will detach and attach" switch on the TinaySA Ultra in DFU mode. Then it suddenly upgraded to 512. According 'version

If I execute the bat file DFU_LOAD_BIN.bat as indicated in the wiki, I get the following error:

(From R&L) I was prepared to re-align the lcd, but found mine is perfect so I can get right to the fun!

incorrect version...that one is for the tinySA, not the Ultra

Looks like I used the wrong firmware. It’s working now! Thanks for the guidance. B Sent: Saturday, December 03, 2022 8:10 PM To: [email protected] Subject: Re: [tinysa] Black screen after firmware

The firmware I used is tinySA_v1.3-506-g8291e1e.bin<http://athome.kaashoek.com/tinySA/DFU/tinySA_v1.3-506-g8291e1e.bin>, following the procedure in

Is it possible to just rotate the display in its case?

Did you use the correct file format (bin) and the specific file for the tinySA Ultra (not the tinySA)? Did you follow the steps in Erik's guide?

Just got new Tiny Ultra. Upgraded the firmware per the document using STM32 Cube Programmer. Upgrade went well and Programmer showed that the upload was completed. After turning the unit Off and On,

Hi, Eric, I've also noticed that when I change the brightness of the display, this setting only applies until TinySA is turned off. It would be good if the brightness setting was part of STORE AS

R & L Electronics Clyde KC7BJE

What are the valid US sources for the TinySA Ultra? Walt Cates, WD0GOF https://wd0gof.com/Hallicrafters Your past has no control over your future. Only your NOW can impact your future.

I received mine from R&L yesterday and immediately noticed the screen was mis-aligned with a tilt that cut off the upper left text.? What a relief it was to have this groups.io where I could learn

Okay, Eric, I understand. I'm gonna describe another little problem. Example: I set the frequency to 50 to 100 MHz. I click on the marker, the marker becomes active. Then I execute: MARKER... MARKER

Should be ok now. The generator and the SA use the same backup locations for frequency and span so when switching between the modes the frequency will always be reset. -- For more info on the tinySA

Hi, Erik, I'm testing version 512 (TinySA reports it as 511). The bug with the ultra band restoration seems to be fixed. Only when switching mode to generator and back, the range is always set to 0 to

In the display driver you have to modify all occurrences of DISPLAY_ROTATION_* In the LCD configuration you have the switch the definition of LCD_WIDTH and LCD_HEIGHT In the touch_position function

Can you guy's test the latest FW release? /g/tinysa/message/8213 -- For more info on the tinySA go to https://tinysa.org/wiki/