开云体育

(From R&L) I was prepared to re-align the lcd, but found mine is perfect so I can get right to the fun!

incorrect version...that one is for the tinySA, not the Ultra

Looks like I used the wrong firmware. It’s working now! Thanks for the guidance. B Sent: Saturday, December 03, 2022 8:10 PM To: [email protected] Subject: Re: [tinysa] Black screen after

The firmware I used is tinySA_v1.3-506-g8291e1e.bin<http://athome.kaashoek.com/tinySA/DFU/tinySA_v1.3-506-g8291e1e.bin>, following the procedure in

Is it possible to just rotate the display in its case?

Did you use the correct file format (bin) and the specific file for the tinySA Ultra (not the tinySA)? Did you follow the steps in Erik's

Just got new Tiny Ultra. Upgraded the firmware per the document using STM32 Cube Programmer. Upgrade went well and Programmer showed that the upload was completed. After turning the unit Off and

Hi, Eric, I've also noticed that when I change the brightness of the display, this setting only applies until TinySA is turned off. It would be good if the brightness setting was part of STORE AS

R & L Electronics Clyde KC7BJE

What are the valid US sources for the TinySA Ultra? Walt Cates, WD0GOF https://wd0gof.com/Hallicrafters Your past has no control over your future. Only your NOW can impact your

I received mine from R&L yesterday and immediately noticed the screen was mis-aligned with a tilt that cut off the upper left text.? What a relief it was to have this groups.io where I could learn

Okay, Eric, I understand. I'm gonna describe another little problem. Example: I set the frequency to 50 to 100 MHz. I click on the marker, the marker becomes active. Then I execute: MARKER... MARKER

Should be ok now. The generator and the SA use the same backup locations for frequency and span so when switching between the modes the frequency will always be reset. -- For more info on the tinySA

Hi, Erik, I'm testing version 512 (TinySA reports it as 511). The bug with the ultra band restoration seems to be fixed. Only when switching mode to generator and back, the range is always set to 0 to

In the display driver you have to modify all occurrences of DISPLAY_ROTATION_* In the LCD configuration you have the switch the definition of LCD_WIDTH and LCD_HEIGHT In the touch_position function

Can you guy's test the latest FW release? /g/tinysa/message/8213 -- For more info on the tinySA go to https://tinysa.org/wiki/

New FW release, Ultra only Version:?v1.3512 Changes: - Bug fixed: Ultramode not always working correctly after load preset. -- For more info on the tinySA go to https://tinysa.org/wiki/

I got mine today from R&L Electronics. This was a pleasant surprise as I had not gotten an email that it had shipped. 73, Don K9AQ

Mine just arrived form R&L Electronics. Ordered on 11/9/22. Now I just need to open it and play! It arrived just in time for our local amateur radio club meeting tomorrow (Saturday). It might make for

Wouldn’t it be a lot easier to just make a plastic or wooden clip to hold the whip at 90 degrees?