开云体育

Thank you ________________________________ Sent: Wednesday, April 13, 2022 1:34 PM To: [email protected] <[email protected]> Subject: Re: [tinysa] Where To Purchase randl electronics

randl electronics

Hello Dick, I have updated my menu text file to the actual firmware version 1.3-347: ReadMe_tinySA_menu_V1.3-347.txt 73, Rudi DL5FA

Thank you ________________________________ Sent: Wednesday, April 13, 2022 8:45 AM To: [email protected] <[email protected]> Subject: Re: [tinysa] Where To Purchase See the TinySA

Has anyone made a Map similar to the NanoVNA one ? Tnx, Dick, W1KSZ

See the TinySA Wiki: https://tinysa.org/wiki/pmwiki.php?n=Main.Buying Sent: 13 April 2022 16:39 To: [email protected] Subject: [tinysa] Where To Purchase A couple of members in the DX Club are

R & L Electronics. I bought mine from them. Mike N2MS

A couple of members in the DX Club are interested in buying a TinySA. What sources would you recommend that sell the "real deal", not some knockoff. Tnx es 73, Dick, W1KSZ

Hello Erik, Thank you very much for the effort you spent into this issue. Meanwhile I contacted my vendor - let's see what will happen. Best regards and hace a happy Easter Martin ---- Am

The purpose of the resistors is to protect the STM32 from the low impedance of a simpel headphone and the purpose of capacitor is to remove the DC offset which headphones don't like. Try a cheap in

Terry, a crystal earphone would be saturated by the output voltage of the STM32 port. On the other hand, I think the main function of the resistors and capacitor is to protect the STM32 port from ESD,

Hi Martin Thanks for the clear image. I've not seen this error before but it is indeed very wrong. Suggest you contact your supplier for a solution. -- For more info on the tinySA go to

Done, Great mod. I had all the components, eve the low profile audio jack, but not the 10uF, after an hour of testing smd on my electronic junk yard, found just one and did the mod. Thanks for the

Hello Erik, Attached please find the photo showing that +60 dBm and -40 are displayed in red color. I took the photo immeadiately after I reset the calibration without power

Hello Martin, one of the RF chip si4432 has been damaged, please contact the dealer to replace the new tinySA.

Martin, Both "+60", "dBm" and "-40" in the left status panel should be red after a successful calibration reset. do they turn red directly after you did the RESET CALIBRATION? (do not switch off/on

Hello Erik, Attached please find the photo taken after I reset the calibration. Things did not change. Regards Martin Am 10.04.2022 um 12:20 schrieb Erik Kaashoek:

One more request Can you do a reset of the level calibration as this could be caused by a failed level calibration CONFIG/LEVEL CAL/RESET CALIBRATION This should change the ref level and bottom level

Dear tinySA Group, Attached please find the requested photo. Best Regards Martin First thing to do is PRESETS/STORE/FACTORY DEFAULTS and power cycle the tinySA Don't connect anything and don't

First thing to do is PRESETS/STORE/FACTORY DEFAULTS and power cycle the tinySA Don't connect anything and don't change any setting!!!!! Take a picture of the tinySA screen (photo using mobile phone is