开云体育

So far as I can see, the given examples show a tracking generator operating over the low range. Is it also possible to sweep the high range? Additionally, how much offset does the current approach

I bought the last unit on AliExpress. Everything must go well.

Current batch is mostly sold. Next production batch is ordered but it may take some weeks before it will be available

See first post on this subject

Would nanoVNA as a tracking generator be an option? Thank you!

Herb, the aliexpress shop from Eriks link points to Zeenko Store. I bought one today morning with paypal as payment source as always. No problems there... Did somebody know this store? Is it safe?

In anticipation of user contributed content I opened the wiki page on [email protected] for all group members The wiki home page can only be edited by me.?Ping me if you need a new subcategory on the

Got mine too a few minutes ago. My order was placed Thursday morning at 6:47EDT or 10:47UTC. This will be my first SA, so I better start to climb the leaning curve.

I just got an email notice from Alibaba that my TinySA has shipped. I probably got in one of the first orders (I went to the site nine minutes after the email arrived) so I may have been near the

Hi DiSlord Thank you very much for clarifying these details Kind regards Kurt Fra: [email protected] <[email protected]> P? vegne af DiSlord Sendt: 28. juli 2020 00:13 Til:

Hi Herb Thank you for the comments. DiSlord has also clarified why these two settings are made I am sure Erik will update the ini file accordingly als the weird behavior with log frequency

Hi Erik I also wondered about this low value. The -27dBm – 3dB is far to low a level but I could not produce a higher level of time of writing. That is simply that my R&S CRTU port 3 which

Here are my measurements. Only settings changed from default where RBW set to manual 10kHz in second measurement both with attenuation set to manual and 0dB First two signals at 0dBm with combiner

DiSlord So now you have two tinySA you can help me with the serial interface so one tinySA can control a second tinySA and do all kind of interesting measurements such as scalar S21 of frequency

Kurt In your document you state: "The combined signal tested with the R&S CRTU-RU And the IOP3 lower than -75dB relative carrier levels so it seem like the TinySA has an build in IOP3 of 4.7dB which

So... I ordered a tinySA today and the purchase page said delivery is estimated to be October 2020. Maybe that is so I won't be disappointed if it had said tomorrow by lunch time <evil grin>. I

DiSlord, I'm sure Erik and hugen would agree that your contributions to the tinySA FW were priceless, and I'm glad the 2 tinySA v0.3 devices did not take as long to reach you as your beta device did

Kurt, When I originally ran TinySA.exe the levels displayed in the application were 3dB different than those on the tinySA display.? I questioned Erik about the difference and he said it was caused

Nice job, Kurt.

TinySA internal for calculation use measure?data * 32, for not send negative values additional add 128 This 32 multiplier need for not use slow floating point calculations, and give error 1/32 ~ 0,03