开云体育

Edition??? Windows 10 Pro Version??? 22H2 Installed on??? ?9/?28/?2020 OS build??? 19045.4046 Experience??? Windows Feature Experience Pack 1000.19053.1000.0 I was running

Looking at the code change, is the increased acceptable range for self-test 9 or is that actuality self-test 10? I ask because my occasional test 10 fails have gone away with this firmware

It is http vs. https. Any site not using https is considered to be insecure. Which does not necessarily mean unsafe. 73 -Jim NU0C "Hans Boon" <pa2hbn@...> wrote:

A multi-band configuration when restored from SD does not restore RBW. Duplicate by changing the RBW followed by a restore. Oddly, the RBW field in the display shows the incorrect RBW actually being

Horace, What version of Windows are you using on the laptop? Roger

That's Great!? Thank you. Yup - just had to read the CONFIG menu list....;-) *PULSE HIGH* enables a trigger signal from the CAL output at the start of each low input sweep.

Hans, It's just Chrome being extra careful about the file type. From Erik's site, it's OK so keep pressing keep! Cheers. David -- SatSignal Software - Quality software for you Web:

Thank you for the link. 1. *Memory Integrity* for both machines are already set to OFF. So this isn't the issue, in my case anyway. 2. *Comm Port Driver* - I don't see any new comm port being added

Yes You may have to enable it in the config menu -- Designer of the tinySA For more info go to https://tinysa.org/wiki/

Hello Erik, I am always getting a message in Chrome about "insecure download" and have click "keep" to download the file. Could it be your website is on some Chrome blacklist. Hans

I took screenshots from the desktop and laptop (STM32_driver_versions.zip). The laptop does not have the STM32 BOOTLOADER under Universal Serial Bus Devices. I was able to get the Driver versions

My bad. No I did not. I just ran the test again with the connection and it passed. Than you for your help. Geo Sent from Proton Mail for iOS

Erik, I was browsing EEVBlog and came across this post: https://www.eevblog.com/forum/testgear/tinysa-sweep-sync-pulse/msg5190552/#msg5190552 The OP talks about a pulse generated at the HIGH output

Did you connect the cal output back to the input?

I bought it from R&L Electronics. Sent from Proton Mail for iOS

Who did you buy it from? Send it back for a refund. Dave

I Just received a new TinySA Ultra, gave it a full charge and it failed selftest #1 and stopped. I turned it off and back on and now it passes #1 but fails #3 (Signal Level Failed). I tried to run it

Here is a link to a discussion of this problem in this group a year ago. /g/tinysa/message/10816 Roger

I wrote about Windows 8 drivers on the Nanovna group. It also applies to the tinysa. /g/nanovna-users/message/31583 Roger

This has been discussed in various forums many times. The TSA can be one of two devices: STM Bootloader or DFU device. Thus two different device drivers. The DFU driver does not get installed