开云体育

That's Great!? Thank you. Yup - just had to read the CONFIG menu list....;-) *PULSE HIGH* enables a trigger signal from the CAL output at the start of each low input sweep.

Hans, It's just Chrome being extra careful about the file type. From Erik's site, it's OK so keep pressing keep! Cheers. David -- SatSignal Software - Quality software for you Web:

Thank you for the link. 1. *Memory Integrity* for both machines are already set to OFF. So this isn't the issue, in my case anyway. 2. *Comm Port Driver* - I don't see any new comm port being added

Yes You may have to enable it in the config menu -- Designer of the tinySA For more info go to https://tinysa.org/wiki/

Hello Erik, I am always getting a message in Chrome about "insecure download" and have click "keep" to download the file. Could it be your website is on some Chrome blacklist. Hans

I took screenshots from the desktop and laptop (STM32_driver_versions.zip). The laptop does not have the STM32 BOOTLOADER under Universal Serial Bus Devices. I was able to get the Driver versions

My bad. No I did not. I just ran the test again with the connection and it passed. Than you for your help. Geo Sent from Proton Mail for iOS

Erik, I was browsing EEVBlog and came across this post: https://www.eevblog.com/forum/testgear/tinysa-sweep-sync-pulse/msg5190552/#msg5190552 The OP talks about a pulse generated at the HIGH output

Did you connect the cal output back to the input?

I bought it from R&L Electronics. Sent from Proton Mail for iOS

Who did you buy it from? Send it back for a refund. Dave

I Just received a new TinySA Ultra, gave it a full charge and it failed selftest #1 and stopped. I turned it off and back on and now it passes #1 but fails #3 (Signal Level Failed). I tried to run it

Here is a link to a discussion of this problem in this group a year ago. /g/tinysa/message/10816 Roger

I wrote about Windows 8 drivers on the Nanovna group. It also applies to the tinysa. /g/nanovna-users/message/31583 Roger

This has been discussed in various forums many times. The TSA can be one of two devices: STM Bootloader or DFU device. Thus two different device drivers. The DFU driver does not get installed

Horace, Can you open the windows Device Manager on both computers and see which driver is installed for the tinySA when connected in DFU mode? ST has released multiple driver versions and you never

New FW release Version V1.4156 Ultra only Changes: - Small selftest update to avoid false positives. -- Designer of the tinySA For more info go to https://tinysa.org/wiki/

Good morning. I spent a few hours trying to update the firmware on my Dell Precision M6700 laptop, an old one, but still reliable. I tried the STM32Cube Programmer and the DfuSE apps but none could

Thanks Erik, I'm an old bloke and all the differing leads drive me crazy!

Any USB C cable should work -- Designer of the tinySA For more info go to https://tinysa.org/wiki/