开云体育

Aha! Shades of "sneaker net". 73, Bill KU8H Bark less - wag more

I have posted on this topic several times but it seems to get buried so I have started a new post for future reference. There have been several posts over the last few months where users have had

On a new installation of Win 10/11 just follow the step-by-step instructions in /g/tinysa/message/10798 and you shouldn't have any problems. You'll have a working TinySA-App

Clyde, did you have to turn off memory integrity on your Win 11 Dell? I haven’t yet updated my SA, but am following this thread with interest. My Dell Optiplex and Asus Vivobook both run Win 11

It even works with my new Dell with Windows 11 and USB 3.01, only, ports. No USB 2.0 adapters or special driver installation programs used either. However, one does have to do an installation,

See message /g/tinysa/message/10590 ( /g/tinysa/message/10590 ) Herb

Funny, I and many others have installed and use Windows and Macs without screwing up our computers. I even use my Android phone and or Tablet to program not only program my TinySAs and NanoVNAs but

On Sun, Mar 26, 2023 at 07:26 AM, allen KC2KLC wrote: > > I think I'm in a similar situation to OP. When I connect my TinySA Ultra > in DFU mode to my Windows 10 x64 desktop, I see "STM32

Hello Group, No matter what I am/was trying to do is/was not working. As I mentioned, I installed the suggested Driver and the Device Manager can see tinySA?in the DFU

You can use the tool you used for the nanoVNA also for the tinySA -- For more info on the tinySA go to https://tinysa.org/wiki/

Hi Erik, do you have a link to the release notes for previous versions? I can't seem to find them if they are available, Thanks, Brian D KF6BL

I think I'm in a similar situation to OP. When I connect my TinySA Ultra in DFU mode to my Windows 10 x64 desktop, I see "STM32 BOOTLOADER" under "Other devices" in the device manager but there's no

Since it was running for some time could it have heated up resulting in an intermittent connection? Does the display have a connector? If so can you reseat the connector?

This is all very weird. I have never seen this before. Just to be sure, you did disconnect? the battery with the device not connected to USB and totally powered off? You could try to load an older FW

Hi For what it is worth i also had issues using the ST32 programmer, the solution for me in the end was to try it on a lap using the same OS etc and it worked first time, i did not bother trying to

Hi Eric, ?forget my email. ?I was using the wrong version. I have both TinySA’s and mixed the versions. 73 Andre PD2AM

Hi Eric, Tried today to update my Ultra but i get the black screen.? The connection and USB cables are checked and ok. I installed my backup i made before and the Ultra started again. This the

I sent over the "scanraw 10M 20M" command, but I didn't get anything out on the terminal emulator. I also wasn't able to get the TinySA Ultra into generator mode. After trying to set the mode through

Hi Paul There is a much simpler way to get screen images saved on the PC Use the TinySA-App from <http://athome.kaashoek.com/tinySA/Windows/> Index of /tinySA/Windows (kaashoek.com) and copy the

Its been ages since my first tinySA installation and I didn't need to do anything extra after adding TinySA Ultra to the mix. I recently set up a new Windows 10 PC and documented the steps I used to