开云体育

Just wanted to provide a bit of a follow-up.? I received the new attenuator and did the same readings. 95.1 ohms center to center center to ground:? 48.8 & 48.5 ohms (readings from both sides which

Thanks for the clarification! Mirek Dne 02.12.2022 v 15:47 Erik Kaashoek napsal(a):

Only a limited set of parameters (Attenuation, start/stop freq) is restored back to before shutdown, all others come from STORE AS STARTUP But after startup you can do LOAD STARTUP to restore

The startup function itself doesn't work somehow, when TinySA is turned on it always sets the last state before shutdown and it doesn't matter what was saved STORE AS STARTUP. Mirek Dne 02.12.2022 v

Next I tested... When I set the upper band and save it as STARTUP, when I turn it on, the STOP frequency is set to 800 MHz and the upper band behaves as off again. The bad behavior is somehow related

Will see if I can replicate this and find the cause. -- For more info on the tinySA go to https://tinysa.org/wiki/

Thank you for the very quick reply, Eric! I did CLEAR CONFIG according to your advice and the behavior is as it should be, it is ok! But it is OK only until I set the range from 1 to 100 MHz and save

Can you do a CONFIG/MORE/CLEAR CONFIG and do the tests again so see if anything changed? -- For more info on the tinySA go to https://tinysa.org/wiki/

Hi, Erik! When I turn on TinySA, Ultra Mode is marked as on. When I turn Ultra Mode off and on again, the sensitivity on the upper band is OK! The error is therefore in the UltraMode reset. And

I can't replicate this. The loss of sensitivity above 800MHz indicates the device does not switch to ultra mode when asked to scan above 800MHz. Can you disable/enable ultra mode after loading the

I set the band 1MHz to 3 GHz PRESET...STORE...STORE1 I perform the calibration CONFIG...LEVEL CAL...CALIBRATE 100 kHz TO 5.34 GHz...CALIBRATE I will connect HP8657B generator, out level -60 dBm

Making the screen width/height variable will lead to substantial increase in code size and lower the speed of display updates. This will not have a high priority -- For more info on the tinySA go to

Hello, I was wondering if it would be possible to add an option to rotate the display 90 degrees on the Ultra? The display on it appears about as tall as the original is wide, so I wouldn't imagine it

Erik, It is OK now. Thanks! Mike

It's the little things.... wrote:

I got mine from R&L today. No need to straighten the screen. Like yours, the lettering is not highlighted. I haven't tried doing the firmware update yet.

Hi all!Happy owner of two TinySA originals here. Just ordered the new Ultra on 11-30 from the Zeenko store on AliExpress. Got the shipping notice today (12-1). Looking forward to receiving it soon to

Running a naked laptop (no protections), I was able to download the files for both the tinySA and the tinySA Ultra and update the FW without issue. The unit I ordered from AliExpress had a crooked

KO now? /g/tinysa/message/8170 -- For more info on the tinySA go to https://tinysa.org/wiki/

Hi, Unfortunately not.