开云体育

Do you know how to use it? Maybe it's interesting. Klaus

I can not remember how many wraps around the ferrite is recommended. I seem to remember more than 3 but, less than 7 for DC power supplies depending on the amp flow and depending on voltage potential.

Good Morning. Erik, this is a pleasure for all of us here in this group. At least I am a guy who is extremely happy when I join this group in the morning and I already read your messages for new

For some new functionality I'm looking for beta testers. Testing includes: - Frequently load new FW and doing a user test of the FW, providing feedback on issues identified - Using the tinySA for

Always run the TinySA with a cable that has ferrites on both ends (I don't understand why the cable that comes with it doesn't have them its not that more expensive). I go even farther and use a

Noticed that I pickup a Frequency of 15-18 MHz when the power cable is plugged in.? Not a issue, just a observation.? I have watched Eric's video and saw that the cable can act as an antenna.? So I

Hi Robin, Very informative, thanks. I took your notes and findings and did a little experimentation with rather interesting results. I have 2 TinySA units so based on your finding and settings, I set

Thanks again Erik.

Short answer. Yes Longer answer. The -25dBm cal output is in reality closer to -26.5dBm and the internal calibration takes this into account. -- For more info on the tinySA go to

After doing level cal, I select mode....cal output with 30MHz.....return to low in and get 30.27681MHz @-26.9DBm. Is this normal to get -26.9, when I read it should be -25DBm(+-0.5)? Please advise

On the contrary, everything that one's licence allows is Amateur Radio. 73, Robin, G8DQX

Panagiotis, there is an issue with the internal level calibration source. Quoting from my own notes on this:

I am one of those who open this site every day looking for news. I, too, was already thinking that life around here would have come to an end.

Sorry, there are too many clones and too many clone vendors and each time I identify a visual issue with a clone they correct the visual issue. Only when you buy from a reputed vendor you can be sure

Thanks Eric for your quick answer. I’m worrying about the accuracy of the power level measurements or the accuracy level of the calibration generator at 30 MHZ. In the photo Nr. 10 the level(after

Pan That vendor is not on the list You can see here https://tinysa.org/wiki/pmwiki.php?n=Main.Buying John -- Sent with a Palm Pilot. Ve3ips.wordpress.com Radio: it's not just a hobby, it's a way of

Why would you not purchase it from an approved vendor? John -- Sent with a Palm Pilot. Ve3ips.wordpress.com Radio: it's not just a hobby, it's a way of life Throw a wire in a tree and go make QSO Rice

Looks good. -- For more info on the tinySA go to https://tinysa.org/wiki/

Hi Eric, I bought it from aliexpress seller : Annoytools Direct Store : Here is the link from where I purchased the TinySa :

Have had at least 10 posts a day here so must be your end, If you are in the states then that would explain it as skip is poor at the moment for the messages. It will improve as ionospheric conditions