开云体育

Switching mode resets all settings. No way to avoid this currently Some measurements also reset all settings but after activating the measurement function you can adjust the external gain or others

Erik, Good morning. There is a small detail that I would like to know if it is a mistake or if it was intentional. When adjusting the external gain (EXT GAIN), it is lost when we enter any item of

Great. Glad to here you got it. 73's Clyde KC7BJE

Issue is resolved, used the STM32 app and only took me a few minutes... wrote:

OK, Thank you. The reason I asked is I have a program that uses a Android, phone or tablet to update the FW on both TinySA and NanoVNA, with absolutely no problems. Super easy. Have you been able to

Thank you! I have not tried the STM32 option so far.... [email protected]> wrote:

No, I can change it after enabeling to the value I entered before. If I stop the output and start again the level changes again. -- Klaus, DL5KV

Tim, I just bought a TinySA (delightful device!) and followed: http://athome.kaashoek.com/tinySA/DFU/TinySA%20Firmware%20Update%20using%20STM32CubeProgrammer.pdf It worked perfectly! 73, David GM8ARV

I do not have an Android phone.

Make sure the tinySA is in DFU mode before running dfu-util -- For more info on the tinySA go to https://tinysa.org/wiki/

Hi Tim, One question if I may, dyou have a android phone like Samsung? Clyde Lambert KC7BJE

Can someone help me with how to upload fw onto the tinySA I'm a relatively new user and apparently doing things wrong. Could somebody lend me a quick hand?

Have you tried tightening the connectors well and redoing the LEVEL CAL.? I downloaded version 1.3325 which is the same one you are using and I made a video playing a similar error to show you. I hope

Klaus, You can enter any number but once enabled it changes the output level is the lowest available level above the requested level In my test FW I've already changed this to be adapted as soon as

If you set a level offset for high mode and want to generate a signal, the level changes on switching on. For example: My setting: leveloffset high output -2.3 If I switch to high output mode and set

Do you know how to use it? Maybe it's interesting. Klaus

I can not remember how many wraps around the ferrite is recommended. I seem to remember more than 3 but, less than 7 for DC power supplies depending on the amp flow and depending on voltage potential.

Good Morning. Erik, this is a pleasure for all of us here in this group. At least I am a guy who is extremely happy when I join this group in the morning and I already read your messages for new

For some new functionality I'm looking for beta testers. Testing includes: - Frequently load new FW and doing a user test of the FW, providing feedback on issues identified - Using the tinySA for

Always run the TinySA with a cable that has ferrites on both ends (I don't understand why the cable that comes with it doesn't have them its not that more expensive). I go even farther and use a