开云体育

Hi Rick, I believe that you stated that you had already received a refund. ?If so, are you expecting to receive another unit as well? —- The facts are these, no matter how you understand your

Do level cal first. Make sure the 30 MHz point in the input curve (if present) stays with 0dB correction The level cal shift all frequencies up/down, the input curve should only take care of the

Hi Erik, many thanks for your great work! I want to do a level calibration of my new TinySA Ultra by using a calibrated signal generator and spectrum analyzer which I’m using at work. Here I have

There seems to be an uptick in black screen events recently. I wonder is it because the user base has become larger or did a Windows update do something odd? 73 -Jim NU0C "Richard B. Emerson"

C'mon, stick with decaf. Whatever contacts I've had with Camii-Direct are via Amazon, which can be presumed to less than secure; act accordingly. The public-facing IP is Verizon's worry. There's at

USPS here has been abysmal on deliveries lately. 73 -Jim NU0C "Richard B. Emerson" <pavilion@...> wrote: -- 73 -Jim NU0C

I believe this is the vendor and item: https://www.amazon.com/Spectrum-100kHz-5-3GHz-Frequency-Rechargeable-Generator/dp/B0CTQFDQBH/ref=sr_1_10?sr=8-10#customerReviews Why is your review not visible

Thanks for the assurance Erik. I just updated to 4.156 via STM cube on W10 pc. As usual no problems, very quick and easy. Self test and self cal all ok. Thanks again. Peter > > >

IMHO, once the item was refunded and a review is rendered I'd cut all communication with the vendor. It may sound like they are waiving a Golden Ticket, a freebe - a true sign of a further scam in the

You have not said whether the update was reported as being successful nor described the method used to update (given there are several). In fact, the same thing happened to me and a brand new TinySA

Yep.? An old Panavise for circuit boards. Comes in handy for many things....even occasionally holding a circuit board.

Erik, given the proliferation of black screens from even valid devices, and discussions about the pros and cons of various programming utilities, I wonder if the documentation most folks see needs an

A friend is heavily involved in O Gauge trains (typically, but not entirely, made by Lionel). The amount of electronics in some locomotives and cars is astounding. John came up with a gizmo called the

The latest FW is OK. Black screens where all caused by failing updates, most probably due to wrong drivers. Once the correct driver was loaded, all was OK -- Designer of the tinySA For more info go to

@KO6BLZ How did you disassemble the attenuator?? I think I have one similar and would like to take it apart and look at or clean it up inside if soldering is poor. Is it possible to take it apart

I have also been holding back on this latest update. There does seem to suddenly be several reports of black screen that we were not ever seeing previously. I’m wary to try an update until this

Hi, In my experience; there is nothing wrong with this update. (Ultra HW:V0.4.5.1) I done fw-update with STM32CubeProgrammer... (I used the bin-file; as described in the pdf) ClearConfig, Calibration,

The point here is to get the OP to read the multitude of discussions on the topic already posted rather than have everyone who contributed type it all in yet again. 73 -Jim NU0C "Bob Ecclestone"

Is it the correct file (and file extension) for the device you have, and the application you are using to perform the update ? For example, I have always used .dfu files, but this depends on the

Hello Jim et al, I am not convinced this problem has been "thoroughly discussed". Whilst there has been a lot of "discussion", there has not been a lot achieved in my opinion. If the "cause" of the