开云体育

Minimum RBW is 2.7kHz

Sorry to ask, Will there be small bandwidth enough to analyse radio transmission? Voice and data. A quinta, 7/05/2020, 17:14, <erik@...> escreveu:

Clear, for the todo list if I have a spare moment....

================================================== Eric, Just a line that you can set the value for and turn on and off.? Primarily used for quick visual indication of of how a measured signal

Would this line also induce some behavior? Like a pass/fail message? Or just a line?

Me too. Not now

I understand there needs to be a frequency limit somewhere, but just wondering why 960mHz.? I would love to see it go to maybe 1.5gHz. Keith

Erik, Another feature I hope you can add to a future wish list is a menu selectable reference line.? It would be a line drawn across the length of the display at a level chosen by the user that could

As the internal flash can endure above 10k write cycles I assume using the internal flash with a warning not to store too often is OK. Saving settings to one of the internal memory slots now also

If storage is a very important function, consider adding a WSON8-packaged SPI FLASH to the current PCB. some SPI connections need to be modified, and consider whether the current MCU has enough

Hi Erik, Digital scope functionality sounds good and thanks for your trace storage addition to the list! Tom, VA7TA

For testing the procedure I'e used is: Both signals are low pass though a 7 or 9 section filter.? They must be clean and the usual source had? HP part numbers. Each signal has its own step

An important parameter of a spectrum analyzer is the spur free dynamic range (SFDR). This is the range in dB between the noise floor and the strongest signals that can be used without generating

I knew that 500 MHz noise generator I purchased a few years back would eventually be of use. - Herb

Outstanding! - Herb

Implemented Under LEVEL added EXTERNAL AMP, value in dB, can be negative. Added status display to warn

Normalize does a "Store" and enables "subtract stored" so it is most useful with a noise generator (or tracking generator) In the settings tab you can change the "Zero level" setting to offset any

================================================================= Glad to hear Erik. I think one of the next most requested features you may be receiving is amplitude offset menu to account for

For good measurement try to keep strongest signal minus attenuation below -20dB if possible

Both