开云体育

It does forget some advanced settings but that's no problem since one can save them in a preset.

I love the fact that my Ultra powers up using the exact same settings last active at the time I powered it off. ? ? This behavior is distinctly different from the original version I have, and

My screen was the same out of alignment. It cut off the top left corner and info on the display, came from R & L. I carefully opened it up, unplugged the battery and carefully pried up the display

Thanks for reminding me. The picture used was from a pre production mockup. Will replace it with a picture from the real device -- For more info on the tinySA go to https://tinysa.org/wiki/

Hi, mine also arrived today via GLS ordered on 11th of Nov. at Eleshop. First test seems very promising, didn't tried ultra mode but the lower end up to 10MHz and the RBW and VBW settings that I

Erik, The main Wiki page shows the following image for the tinySA Ultra: The input maximum RF level is labeled as +10dBm and maximum DC voltage as 10VDC.? On the delivered tinySA Ultra's, the input

Yes, please do -- For more info on the tinySA go to https://tinysa.org/wiki/

I opened mine up and shifted the screen. It is attached with a small ribbon and nothing to actually hold it in place. Maybe the front has a slight indent? I just moved it around and made sure the

I ordered the Tinysa ultra at 19th November from Zeenko store, Aliexpress, China, and the instrument just arrived to my hands. after turning it on, I quickly noticed that the screen is not well

Should be ok -- For more info on the tinySA go to https://tinysa.org/wiki/

Hello everyone, I calibrated my new tinySA after it successfully passed all self tests. After the calibration finished (without any indication of a problem), I fed the 30 Mhz calibration generator

Hi all, just received mine. Ordered 10th Nov. at Eleshop, shipper GLS delayed one additional day - now screwing on SMA port savers :-) Arno

Also, I believe Jim Allyn - N7JA said, "I think of it this way: male in means you can screw the attenuator directly on to the transmitter output."? I will say that while this proves true for my

Just wanted to provide a bit of a follow-up.? I received the new attenuator and did the same readings. 95.1 ohms center to center center to ground:? 48.8 & 48.5 ohms (readings from both sides which

Thanks for the clarification! Mirek Dne 02.12.2022 v 15:47 Erik Kaashoek napsal(a):

Only a limited set of parameters (Attenuation, start/stop freq) is restored back to before shutdown, all others come from STORE AS STARTUP But after startup you can do LOAD STARTUP to restore

The startup function itself doesn't work somehow, when TinySA is turned on it always sets the last state before shutdown and it doesn't matter what was saved STORE AS STARTUP. Mirek Dne 02.12.2022 v

Next I tested... When I set the upper band and save it as STARTUP, when I turn it on, the STOP frequency is set to 800 MHz and the upper band behaves as off again. The bad behavior is somehow related

Will see if I can replicate this and find the cause. -- For more info on the tinySA go to https://tinysa.org/wiki/

Thank you for the very quick reply, Eric! I did CLEAR CONFIG according to your advice and the behavior is as it should be, it is ok! But it is OK only until I set the range from 1 to 100 MHz and save