Re: Ok, Boys, Here's your next Project . . .
Just wondering what this has to do with the TinySA????
KC7BJE CLYDE
By
Clyde Lambert
·
#3012
·
|
Re: Signal Generator UK CB
It's not possible to define a channel setup.
--
------------------------------------------
For more info on the tinySA go to https://tinysa.org/wiki/
By
Erik Kaashoek
·
#3011
·
|
Signal Generator UK CB
Loving the TinySA, a great piece of gear which I'm using more and more.
Just wondered,? UK CB use an odd frequency range. 40 chanels from 27.60125MHz to 27.99125MHz in 10KHz sreps. Is there a
By
Ian
·
#3010
·
|
Re: Default parameters when TinySA is switched on
I do not agree
The amount of writes to the flash memory is limited so you do not want to write without need.
The PRESET/STORE/STORE AS STARTUP is there if you want to start with certain
By
Erik Kaashoek
·
#3009
·
|
Default parameters when TinySA is switched on
Hi. Every time the TinySA is switched on, it doesn't remember its previous state and starts with the default factory parameters (e.g. Low band, Frequency from 0.1MHz to 350MHz, auto mode, etc). In my
By
Andrea I2UEA
·
#3008
·
|
New FW release: Added battery indicator to output menu and solved auto attenuation bug
New FW release
Version v1.1-85
Changes:
- Battery indicator added to output menu
- Attenuation will decrease when auto attenuation is on and no maximum is found.
The second change solves the problem
By
Erik Kaashoek
·
#3007
·
|
Re: Tinysa tracking generator
#feature_request
Hello,
good job John W7 and Erik , I used also the same local oscillator and ERA amplifiers and RMS mixer from MiniCircuit,
then calibrated Tinysa and TG with precision SA and rubidium
By
Sandro.montana@...
·
#3006
·
|
Re: Ok, Boys, Here's your next Project . . .
Here you go:
https://arxiv.org/pdf/2009.14383
Cheers,
Kaj OH6EH
By
Kaj Wiik
·
#3005
·
|
Re: Ok, Boys, Here's your next Project . . .
I'll have to see if I can find the paper and see how they're processing as I'm guessing now that they're up to 1000GHz as a Hackaday article noted a while back I recalled too reading into... a 600MHz
By
jafinch78 .
·
#3004
·
|
Re: What to do when a selftest fails
Hi Folks:
Like a few others of you, I suspect I somehow fried the input attenuator chip on my tinySA.
I picked up two of the newer replacement attenuator (PE4312) chips for about $4 each, and after
By
stephenmahrer@...
·
#3003
·
|
Re: Shift for displayed marker frequency
#feature_request
The SW is open source, feel free to create different FW's
--
------------------------------------------
For more info on the tinySA go to https://tinysa.org/wiki/
By
Erik Kaashoek
·
#3002
·
|
Re: Shift for displayed marker frequency
#feature_request
How about having different firmware's that you can load that is tailored to perform more in depth testing, it only takes a minute to load firmware and re-calibrate?
By
N8AUM
·
#3001
·
|
Re: Ok, Boys, Here's your next Project . . .
Very cool, thanks for sharing that!
73,
Robert, WA2T
By
Robert Entwistle
·
#2999
·
|
Re: What to do when a selftest fails
Replaced with the PE4312 today. ?Self test passing again!
By
Brad Jeffries
·
#2998
·
|
Re: Ok, Boys, Here's your next Project . . .
"But it *only* goes up to 20 GHz! (lol)."
As we used to say in the Old Country: "Ja, Wel, No, Fine"
I came upon a temporary name for the beast: BMF Teensy Tiny SA. Especially
if
built in
By
stefan baartman
·
#2997
·
|
Re: Shift for displayed marker frequency
#feature_request
Good proposal,
Just like an "external amp" I'd prefer an "external conversion" that shifts everything frequency related (+ is upconverted, - is downconverted). Would be nice if it fits in the
By
Erik Kaashoek
·
#2996
·
|
Re: Ok, Boys, Here's your next Project . . .
But it only goes up to 20 GHz!? (lol).
By
Bruce KX4AZ
·
#2995
·
|
Shift for displayed marker frequency
#feature_request
Hi,
when aligning superhet receivers it could be handy to see frequency for marker with +-IF. Probably it could be as another item under Measure menu? IF could be set in Config menu.
What do you
By
Andrey Denisyuk
·
#2994
·
|
Re: Ok, Boys, Here's your next Project . . .
Thinking [email protected]?needs the reminder as well and more-so.? B^|)
By
jafinch78 .
·
#2993
·
|
Re: Ok, Boys, Here's your next Project . . .
Won't buy it until it has the Erik/Hugen Seal Of Approval . . .
By
stefan baartman
·
#2992
·
|