开云体育

The SMA connectors on the TinySA? were never meant for hundreds of connect/disconnects and will wear out eventually especially if the center pin is allowed to rotate and "drill out" the SMA jack. A

Thanks for the response Miro. I came across Don Jackson's article after I posted my remarks. A similar well thought out design for a high power rf sampler can be found in the May 2011 issue of QST on

See this post also. /g/tinysa/topic/78971178#2334

I had the same problem. You may need to manually update the device drivers for the ST DFU Se Demo program. Look in device manager for that device and update the drivers by pointing to the top level

I used to be able to program firmware for NanoVNA and TinySA on my main computer but after installing the STM Cube IDE and Cube Programmer, neither is recognized when set to DFU mode. Works fine for

Ed, I had a problem with my Dell i5 W10 64bit computer using DfuSe, it would not update either of my TinySA's and in trying to force them I ended up with a white screen on both. I then downloaded

I am not sure what is going on here. I was originally having trouble connecting with the TinySA on my primary ham radio computer and took it over to another computer and had success. I went back to

Mike Millen answered this question for me last week: /g/tinysa/message/2642 Driver install is necessary.

You can also try tinySA-App to do the FW update -- ------------------------------------------ For more info on the tinySA go to https://tinysa.org/wiki/

I am unable to update the firmware on my TinySA using a DFU file or a bin file. The current firmware version on my TinySA is v1.1-12. I have downloaded and installed the DfuSeDemo tool. When I place

The original announcement explains the modification(s) and can be found in the groups.io/g/tinysa messages section ——> /g/tinysa/message/2680

My opinion is that it depends on what you are measuring ?I am not sure of the linearity of the antenna when spanning a hundred MHz. A direct tap frequency response can be measured with a VNA to

My previous comment may have been not clear. Feel free to share information about which sellers are selling clones but please do not share information on the mistakes the cloners made that allow us to

Thanks; that is good to know. The Banggood fake also fails self-test, see below. Grü?e, Carsten

Dumb question here.... You guys are trying to check the output from your transmitter, right? Don't you have enough RF in your shack that you could just us the tinySA antenna to get enough signal to

Evan/Miro Do you have an opinion about a tap as you suggest vs. sampling the signal. (few turns of wire around a through RF connection, and depending ?on the resultant Magnetic coupling inducing

Hi Dennis! inductive coupler still requires dummy load, and if you have one, then your resistive attenuator does not need "large power absorbing resistors". In another thread in this group someone

Thanks for replying and supporting us users! Yes - it was from eBay and on the list. I wish I had checked the forum before ordering! ;-) Am sending it back.

Kind request to NOT discuss in this group the mistakes made by the cloners!!!!!!! -- ------------------------------------------ For more info on the tinySA go to https://tinysa.org/wiki/

Well, the label looks just like mine except the S/N is SA-20090482. Zack yahoo.co.uk@groups.io>