¿ªÔÆÌåÓý

  1. Tinysa
  2. Messages
Single Messages Topics Expanded Polls

Re: Minor Bug report and big thank you !

 

¿ªÔÆÌåÓý

Herb,

I cannot confirm this error. I did upgrade to version 1.0.80 too and did the following experiment:
- connected High-and Low ports with a short semiflex cable.
- CW Generator on High Port on (10 MHz) with choosen into Low Input (pic 1)
- then FREQUENCY->STOP 45 MHz (pic 2)
- turned? HARMONIC Measurement on (pic 3) -> everything looks OK
- turned HARMONIC Measure off (pic 4)

So I cannot confirm the results...

I will try again with an external Signalgenerator later..

Chris
 ---
'Everything should be made as simple as possible, but not simpler.' -- Albert Einstein
Am 10.09.2020 um 15:41 schrieb hwalker:

On Thu, Sep 10, 2020 at 01:55 AM, Erik Kaashoek wrote:
Can you test with the latest FW?
Erik,
? Using Manuel's settings, I can confirm the issue he reported using the latest version 1.0-80.? Setting up the measurement using 'Measure->Harmonics', I could only see the GHz suffix appear briefly in the 3rd marker.? After turning off ''Measure->Harmonics' the 3rd marker mostly showed the incorrect value with GHz suffix. The correct value would appear intermittently.? Also, very strangely, a 4th marker would flash in very briefly of its own volition.?

? Incorrect 3rd marker value? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ? ?Correct value appearing intermittently
??? ??


?- Herb

10MHz CW into LOW.jpg
10MHz CW into LOW_Stop 45MHz.jpg
10MHz CW into LOW_Stop 45MHz_Harmonics-measure-off.jpg
10MHz CW into LOW_Stop 45MHz_Harmonics-measure-on.jpg

Join [email protected] to automatically receive all group messages.