On 26 Aug 2021, at 19:30, Terry Perdue <K8tp@...> wrote:

It's at step 8 that I run into trouble - the app doesn't show the device. If it did, I'm sure there would be no problem.

On 8/26/2021 11:25 AM, avvidclif wrote:

I haven't updated my Tiny SA in a couple of months so I thought I would give it a try. here's step by step
Computer running Win 10 latest 64 bit.
1. Plug in USB cable to computer
2. Turn on SA
3. Plug in cable to SA
4. On SA open menu and go to config
5. Go to DFU
6. Make sure Enter DFU is highlighted
7. Start DFU Demo on computer
8. It should show an STM device in demo mode at top of screen
9. Go to Eric's site and download the DFU to the download folder on the computer
10. On DFU Demo go to bottom right and select "choose"
11. It goes to the download folder and then click on the DFU file
12. Click on upgrade, takes abt 3-4 seconds.
13. Turn SA off and the back on. It should come back up ready to use.
14. Close DFU demo.

These are the exact steps I followed and have been following, no fancy setup, nothing

--
Clif at AVVid