OK - here is my take on the "minimal" tinySA case - sized to only accept the tinySA with no accessories (but I think the guitar pick should fit in the space between the sma connectors).? As before, I am just uploading the files here for those who may want to print it, prior to creating another "thing" on thingiverse.? If anyone does print it, PLEASE provide feedback and confirm fit.??
As before, there are two versions which share a common lower case.? The upper case changes depending on whether you have the correct foam pieces to use in the upper case (roughly 3.25mm/1/8" thick neoprene).
If you DON'T have the foam, print the 'nofoam' upper case.
If you DO have the foam, print the 'foam' upper case.
All previous comments in this thread (and the original Thingiverse page for post printing still apply), and the hardware is still the same (M3 x 40mm SHCS x 2, M3 nylon locknut x 2, M3 washer x 4).
Thanks
