Nice!? I see you have some longer SMA connector savers (I assume that's what they are).? Those look longer than the ones I accounted for.? Do you have a similar attenuator in there that you can check to see if it fits in those slots (at least the left one) and still lets the lid close?? As I mentioned above, I caught an error in the upper case that may prevent the lid from closing on those.? I just fixed my models and will add new STL files to my thingiverse page in just a bit.? I also increased the height of the space beneath the "bridge" that supports the tops of the attenuators in the hope that it will provide room for both cables, even when they are stacked on top of each other.? My original only had enough height for one cable, so they had to nest side by side (or one bend inside the other bend).
Mine didn't have an issue because I printed it prior to making the adjustment for the connector savers.
If you have support material under that bridge between the connectors, you can remove it and the cables should tuck into the space under it so they only need one bend - that might not have been obvious from my earlier photos.
Finally, here is a screen grab of a smaller footprint option for those with a smaller printer bed.? This one is 135mm wide and 120mm front-to-back (plus about 10mm for the hinges).? It sacrifices some space in that left compartment , and I am not 100% sure that the cables will still fit, but I think they should (especially with the change in the clearance under the bridge).
I honestly don't know where I got the foam - it was something I had on hand - I may have grabbed it from work a long time ago.? I will do some googling and see if I can get an idea of what it is.? The backer was labeled "3M Bumpon".
There is an alternate model with protrusions for that upper case that may be used without foam, or possibly with a very thin rubber or foam pad, but if you choose to print that - WAIT until I upload the new versions with the correction to that attenuator hold-down feature!? They will be named with today's date (072021a).? You would want the one with NOFOAM in the title.
