Thanks for feedback! You are right, of?course?, I have to adjust the output?level down before I start increasing!!! I don't have the "level -50".?
I have also noticed the "amplifier" function too, I've not implemented this function. I suppose this function is to be used when adding an external amplifier, is this example correct? Output level to be set as -6dBm, 20dB external amplifier resulting in an output signal og 14dBm and the output level indication is 14dBm. Output level can now be adjusted to 10dBm and the "internal" level will automatically be adjusted?to -10dBm, but not shown on the display.... is this correct?
Best regards
Karl Jan - LA3FY
s?n. 20. des. 2020 kl. 07:44 skrev Erik Kaashoek <erik@...>:
On Sat, Dec 19, 2020 at 01:11 PM, Karl Jan Skontorp wrote:
The console command for increasing amplitude is not working, "levelchange 30" should start with a "low amplitude and increase it 30dB. This is not working, while the "levelchange -30" workes nice!
Hi Karl,
I can not replicate the bug. These are the commands used: mode low output level -50 output on levelchange 30 and the 10MHZ signal swept from -50dB to -20dB. Can you list the commands that replicate the bug? ? --
