Gregg, if you would, could you post a link to that video please??
I just searched for 'AG0AG' and usually the content provider shows
up but I am getting nothing.? I would appreciate it!
Thanks,
Bob Ruth
On 7/7/24 12:16, Gregg Lebovitz (kd1mu)
wrote:
toggle quoted message
Show quoted text
I
am following a video on YouTube by AG0AG to build a tap
attenuator out of 2 watt resistors. As it is a tap, it gets 60DB
attenuation while running the bulk of the signal to a dummy
load. I have a 100 watt and a 1500 watt dummy load.
?
All
the parts came from Ali and totaled $12.
?
I
will construct it next week, but I am expecting good results. I
also bought a ceramic 50 ohm attenuator and a heat sink to mount
it on. This is to attenuate the signal from the rig to the amp.
It seems to do the job.
?
The
alternative was $90 for a 100 watt attenuator and $15 for a 10
watt one.
