Eric,
I followed you video and found what I was doing incorrectly even though I was using a stylus.
One has to touch the extreme upper left hand corner and the extreme lower right hand corner to get the correct settings. I was only touching in the general area.
Thanks,
Mike N2MS
On 10/07/2020 10:08 AM Erik Kaashoek <erik@...> wrote:
Can I suggest you fredo the touch calibration?
In particular the bottom of the screen calibration is fairly critical.
If you have to press MODE to enter CONFIG you did not touch the screen during calibration close enough to the bottom
The data is automatically saved
when doing the touch test check if a horizontal line at the bottom of the screen is correctly under where the screen is touched.
I have no video yes of the touch calibration. Good suggestion.
