Eric,
I have two TinySA units.
I updated the firmware on one and restored the settings and it is working correctly.
I updated the firmware on the second unit and did a CLEARCONFIG , performed a TOUCH CAL, TOUCH TEST, CALIBRATION and VERIFICATION.
The issue I have with the second unit is after the? TOUCH CAL and TOUCH TEST the menus are not aligned correctly. For example I have to press MODE to enter CONFIG.
How can I properly execute the TOUCH CAL and TOUCH TEST? How do I SAVE it? Would you have a video sowing this procedure?
Mike N2MS
On 10/07/2020 7:41 AM Erik Kaashoek <erik@...> wrote:
New FW release
Version v1.1-9
Changes:
- Disabled serial console due to insufficient space
- Added THD measurement so MEASUREMENT/MORE menu
