On Fri, Oct 2, 2020 at 09:59 AM, hwalker wrote:
? I downloaded v1.0.203 and had the following observations:
? 1.? Looks like you did manage to sneak a new icon in before release.
? 2.? The only confusing references I could still find to the NanoVNA were:
? ? ? ?a. Settings->VNA Settings:? Change to 'tinySA' Settings
? ? ? ?b. Settings -> Threshold: Remove or disable
? ? ? ?c. S1P and S2P buttons: For the tinySA one of these buttons is probably redundant.? Both recall the same waveform when using the M1-M3 buttons.
3? The 'mode' command does not return the current input mode, so there is no way to let the user know if the frequency range is inappropriate for the current input mode.
4.? If the entered frequency range changes from low to high, then there should be a warning alerting the user? to change ports at the applicable cross-over point.
5. Can the S11 | S21 notations in the following screen capture be changed to tinySA specific equivalents?
I haven't heard much from Cathy lately, but I suspect this version of tinySA-App would be more towards her liking.
===============================================
Erik,
? Hopefully you already read this in my earlier post but in-case not....
?? The 3 middle buttons pertain to built-in NanoVNA firmware and need to be disabled and eventually removed.
- Herb
