开云体育

Hi, I think that I understood distortion, but checking it what you mentioned was that you got no clear output like in YouTube videos. If the problem is sideband (and spectrum) inversion, this can be

Ignacio, That all sounds logical. It sounds like I need to open up the Audio Sampling Rate from 96K to the maximum. I think it is around 197K. I don't believe I said distortion? I said the SSB was

Ok, now the time here is good for responding, yesterday it was very late (3:23 AM). I have recovered the info of my Softrock 40 receiver (first model) and the SoftRock II Lite that is the model that

Correction to my last message: The Softrock II Lite is crystal controlled, so you cannot tune it, I was misled by the SoftRock that I use that is synthesizer controlled. It is too late here but I can

George, Tony Parks is the father of the SoftRock series of receivers so he have investigated the radio quite well. Probably you?ll have to test your Softrock receiver with an antenna and practice

Gee, maybe you should have read what I wrote first and invesrtigated the radio before commenting? Then you would have known what I was talking about?

Good Afternoon Group, The mention of 1/3 subharmonic sampling and SDR tuning made me pause. I think I use to know this but it seems at almost 81 years old lots of things don't stay in my memory very

George Sorry, did not think that it might be that old:-) Then the SDR tuning will be fixed and not show the rig's frequency unless you set it manually, only practical if you rarely move

My bad. The Crystal is 11.9 MHz.

I have several since I could not figure out if it was a hardware issue or a software. I have HDSDR, WinSDR, SDRadio. The FT-301D's IF is about 9 MHz. The SRL II Oscillator is 11 MHz, but it is 1/3

George, You do not say what software you are using. My settings using HDSDR https://sites.google.com/site/g4zfqradio/hdsdr-if-pano Stick with 48KHz sampling until you get it working properly. Turn

Greetings. I own a Yaesu FT-301D and saw an article about adding a SoftRock Lite II. I am a newbie to SDR but I have been in electronics a long time and know how to install and use hardware and

Thank you Guido, That is my motto, your comments are spot on. I am alway reading your pleasant and informative blog. http://pe1nnz.nl.eu.org/ I do have a loop that was gifted to me and I will give it

Good afternoon Guy, Thanks for sharing these perspectives and ideas. The softrocks are great, and you might also considering combing it with an active antenna or small loop, as an alternative for

Thanks for posting. Perhaps I can get started again!

Good morning folks. I noted that there is only one posting this month. I also noted that I am now getting off my butt after I had my second right cerebral stroke on Oct22 2021. What an experience

The W6SFM Samuel F. Morse Amateur Radio Club in Sacramento, CA would like to remind you that our Bug Roundup event will be held THIS Weekend! The Bug Roundup Event is a special time to bring bug

73 pete m0fmt

Good Morning Tony, Thank you very much for your kindness. Regards, José María, EA4B

Good Morning Jose, Please send your mailing address to me at kb9yig@... and I will mail a letter to you with a 74AC74 contained within at no cost to you. Regards, Tony, kb9yig